10 February 2020 in Applied Physics Letters
We present and analyze characteristics of the runaway electron flow in a high-voltage (the voltage rise rate of up to 1.5 MV/ns) air-filled electrode gap with a strongly nonuniform electric field. It is demonstrated that such a flow contains a high-energy electron component of duration not more than 10 ps. According to numerical simulations, runaway electron generation/termination is governed by impact ionization of the gas near the cathode and switching on/off a critical (sufficient for electrons to run away) electric field at the boundary of the expanding cathode plasma. The corresponding characteristic time estimated to be 2–3 ps is defined by the ionization rate at a critical field.
16 April 2018 in Applied Physics Letters
Fulfillment of the condition that the voltage rise time across an air gap is comparable with the time of electron acceleration from a cathode to an anode allows a flow of runaway electrons (REs) to be formed with relativistic energies approaching that determined by the amplitude of the voltage pulse. In the experiment described here, an RE energy of 1.4 MeV was observed by applying a negative travelling voltage pulse of 860-kV with a maximum rise rate of 10 MV/ns and a rise time of 100-ps. The voltage pulse amplitude was doubled at the cathode of the 2-cm-long air gap due to the delay of conventional pulsed breakdown. The above-mentioned record-breaking voltage pulse of ∼120 ps duration with a peak power of 15 GW was produced by an all-solid-state pulsed power source utilising pulse compression/sharpening in a multistage gyromagnetic nonlinear transmission line.
2 November 2020 in Applied Physics Letters
We present the results of experiments on generation of high-power superradiant (SR) pulses by an extended electron bunch moving in a cylindrical surface-wave structure with two-dimensional periodical corrugation. In such a structure, azimuthally propagating wave fluxes are excited, which synchronize radiation from different azimuthal segments of a tubular electron bunch with a diameter greatly exceeding the wavelength. This facilitates a drastic increase in total electron current and, correspondingly, in SR pulses peak power while maintaining the azimuthal coherence of the radiation. In experiments carried out, subnanosecond 90 GHz SR pulses with a record-level peak power of up to 150 MW and an axially symmetric directional pattern were generated. The results of experiments are in line with the theoretical predictions based on the quasi-optical approach and direct particle-in-cell simulations.
28 February 2022 in IEEE Electron Device Letters
This letter reports new results on the formation of a paraxial flow of runaway electrons emitted in an elongated air gap near the tip of a conical steel cathode. In the axial magnetic field > 4 T, the peak current density of ≈ 0.6 kA/cm 2 has been achieved in the bunch core with a 0.7 mm diameter. Similarly to the vacuum case, dependence of the bunch parameters on the magnetic field was obtained and interpreted. Analysis of recorded current waveforms and oscilloscope transient response shows that the original current pulse rise time and width did not exceed 5 and 10 ps, respectively. Using the time-of-flight method, we have estimated the particle kinetic energy (≈200 keV) at the peak of the distribution function.
26 August 2019 in Journal of Applied Physics
This paper presents new experimental data that enable the observed processes in nonlinear ferrite lines to be related with the theoretical positions of the spin waves of the magnetization precession under the conditions of a high-power microwave. Such an approach has not been considered in earlier discussions on the subject and can contribute to the theory of the generation of oscillations in a gyromagnetic ferrite medium. These new aspects were used to design a new type of generator. The specific feature is the presence of regularity in the ferrite lines in the generation mode of microwave oscillations. The repeating regularity enabled the implementation of multistage pulse shape converters capable of operating in two modes and providing extreme parameters of the output pulses. Two variants of multistage converters of nanosecond high-voltage pulse shapes with a duration of ∼4 ns at a half-height and with an amplitude of −500 kV were designed and tested. The assembly of the converters and the driving generator are described in the stationary setup. In the first case, the rise time shortened to ∼45 ps, and the amplitude increased to −850 kV due to the sharpening of a pulse and the formation of a shock wave by the cascade of three nonlinear transmission lines. A record rate for the increase of the leading peak voltage of ∼15.5 MV/ns was reached. In the second case, the new approach for the generation of a sequence of subnanosecond pulses was presented and tested, and each pulse of the previous stage was modulated by the next stage doubling the number of pulses while conserving a deeper modulation. As a result, at the top of the incident pulse, a sequence of subnanosecond peaks with a large modulation depth (∼70%) was formed when the maximum voltage amplitude reached −700 kV. The results of the emission of such pulses are also presented.
1 October 2012 in Technical Physics Letters
The possibility of in-phase excitation of two independent nanosecond-pulsed relativistic 37-GHz backward-wave oscillators (BWOs) with high-current electron beams has been studied. This regime can be...