Solar irradiation can be converted into electrical current by a solar cell, which in turn can be stored in a supercapacitor. The coupling of a solar cell and a supercapacitor, called photosupercapacitor, shows promising applications that demand multidisciplinary studies to understand its functionality and potential. Normally, supercapacitors are characterized with potentiostats or power sources that provide a constant current or voltage, however, we find that the photocurrent provided by a solar cell in a photosupercapacitor configuration largely depends on the voltage stored in the supercapacitor connected in parallel to the solar cell. Therefore, we use a simplified equivalent circuit model to demonstrate that the charging time of a photosupercapacitor depends mainly on its capacitance, and to a lesser extent, on its resistance. At the same time, the maximum output voltage of the photosupercapacitor depends on the saturation and short circuit currents of the solar cell. The numerical results confirm qualitatively the experimental behavior of the photo-charging curves of quasi-solid supercapacitors, which consist of polyvinyl alcohol (PVA)-H2SO4 electrolyte for both activated carbon or reduced graphene oxide-based electrodes. The latter presents better electrochemical characteristics that optimize the operation of the photosupercapacitor. The electrical circuit analysis is a useful tool to guide further improvements in the photosupercapacitor design and fabrication.
18 February 2020 in Journal of Electronic Materials
The impact of magnetic fields on the morphology of hybrid perovskite films is assessed via scanning electron microscopy and X-ray diffraction. Small-grain non-uniform perovskite films are obtained when a large magnetic flux density is applied to the sample during reaction of PbI2 and methylammonium iodide (chloride). Similarly, X-ray diffraction reveals a change of preferential crystalline planes when large magnetic fields are applied. Furthermore, we experimentally demonstrate that the quality of the perovskite film is affected by the magnetic field induced by the magnetic stirring system of the hot plate where the samples are annealed. As a consequence, optimization of the perovskite layer varies with magnetic field and annealing temperature. Finally, we prove that uncontrolled magnetic fields on the environment of preparation can severely influence the reproducibility of results.