In this paper, On-Off Keying (OOK) free-space optical (FSO) communication with coherent detection and double adaptive detection thresholds (CD-DADT) is proposed. The 3-bit encoding and double adaptive detection thresholds presented in the scheme can significantly improve the system performance, and there is no need of acquiring the instantaneous channel state information (CSI) and probability density function (PDF) of turbulence model. In order to enhance the accuracy of the threshold even further, decision-aided method is offered to set the second detection threshold. The PDFs of the detection thresholds and the average bit error rate (BER) of the system are theoretically derived. Numerical studies show that the performance of the system is comparable to the performance of the idealized adaptive detection system and the loss of signal-to-noise ratio (SNR) performance is only 1 dB at a BER of 10-9 over a lognormal turbulence channel with normalized standard deviation of irradiance σ=0.25 and phase noise with normalized variance $\sigma;_{\oslash}^{2}$ 2=0.07. Hence, this scheme can contribute to the performance improvement of the FSO system and its practical realization.
In this study, we propose a non-data-aided algorithm of the cycle slip self-correcting carrier phase estimation (CSSC-CPE) which mitigates the cycle slips caused by blind CPE in the coherent wireless optical communication (WOC) system. The CSSC-CPE uses the output of CPE for cumulative averaging and selects the difference $\delta $ between two cumulative average segments as the discriminant parameter. The location and direction of cycle slips are determined by identifying the position and sign of the peak value of $\delta $ . The optimal thresholds for cycle slip detection could be derived from the probability density function (PDF) of $\delta $ obtained by calculation and deduction. Finally, numerical simulations and indoor experiments are carried out. The results show that CSSC-CPE can effectively eliminate cycle slips under weak turbulence condition. Compared with relative non-data-aided cycle slip correction algorithms, the CSSC-CPE achieves a better performance in suppressing the phase noise generated by atmospheric turbulence and laser linewidth, which enhances the accuracy of the cycle slip identification and lowers the SNR requirement when the cycle slip is not allowed.
The strain caused by device packaging was studied in high-power semiconductor laser bars by measuring the degree of polarization. Polarization measurement with intentionally GaAsP-GaInP strained laser bar packaged on a Cu heat sink for 799-nm emission revealed the variation of band edges between the conduction band and heavy-hole or light-hole bands in the active region. This served as a method for evaluating the strain. In the packaging process, a maximum of 1800-ppm strain was transmitted to the active region. It was found that the defect density of 14.3% was induced.
Optical wireless communication (OWC) systems can exhibit high percentage availability, yet suffering from frequent intensity fades caused by turbulence effects and pointing errors. The intuitive method to character the link is using commercial bit error rate testers (BERT) by measuring the output sequence of the receiver, which provides limited information. Thus we propose the algorithms for measuring the outage and synchronization performance, bit error rate (BER), throughput, and fading statistics. The inputs consist of decoded baseband data sequence and received optical power, so that it's suitable for different modulation formats. Both the bit level and packet level measurements are presented. Then a fading characterization tester (FCT) having these functions is implemented based on a field programmable gate array (FPGA). Our indoor experiment reveals the measurement accuracy of the FCT by comparing the measured results with the derived theoretical ones. Another 1.9km OWC experiment is also carried out. These measured results by FCT are presented, which can not only measure the OWC link, but also help the researchers to improve the system performance, such as the design of error correction approaches like forward error correction, the design of packet based network protocols.