26 September 2010 in Nature Materials
25 October 2010 in Applied Physics Letters
We propose a longitudinal spin-Seebeck effect (SSE), in which a magnon-induced spin current is injected parallel to a temperature gradient from a ferromagnet into an attached paramagnetic metal. The longitudinal SSE is measured in a simple and versatile system composed of a ferrimagnetic insulator slab and a Pt film by means of the inverse spin-Hall effect. The experimental results highlight the intriguing character of the longitudinal SSE due to its own geometric configuration.
21 August 2011 in Nature Materials
15 May 2012 in Journal of Applied Physics
The spin-Seebeck effect (SSE) in ferromagnetic metals and insulators has been investigated systematically by means of the inverse spin-Hall effect (ISHE) in paramagnetic metals. The SSE generates a spin voltage as a result of a temperature gradient in a ferromagnet, which injects a spin current into an attached paramagnetic metal. In the paramagnet, this spin current is converted into an electric field due to the ISHE, enabling the electric detection of the SSE. The observation of the SSE is performed in longitudinal and transverse configurations consisting of a ferromagnet/paramagnet hybrid structure, where thermally generated spin currents flowing parallel and perpendicular to the temperature gradient are detected, respectively. Our results explain the SSE in terms of a two-step process: (1) the temperature gradient creates a non-equilibrium state in the ferromagnet governed by both magnon and phonon propagations and (2) the non-equilibrium between magnons in the ferromagnet and electrons in the paramagnet at the contact interface leads to “thermal spin pumping” and the ISHE signal. The non-equilibrium state of metallic magnets (e.g., Ni81Fe19) under a temperature gradient is governed mainly by the phonons in the sample and the substrate, while in insulating magnets (e.g., Y3Fe5O12), both magnon and phonon propagations appear to be important. The phonon-mediated non-equilibrium that drives the thermal spin pumping is confirmed also by temperature-dependent measurements, giving rise to a giant enhancement of the SSE signals at low temperatures.
27 December 2010 in Applied Physics Letters
This paper reports that the longitudinal spin-Seebeck effect appears even in a sintered polycrystalline Mn-Zn ferrite slab. The effect drives a spin current flowing across an interface between the slab and an attached Pt film along a temperature gradient and it generates electric voltage via the inverse spin-Hall effect in the Pt film. Since the observed phenomenon enables thermal generation of electric voltage from commonly used polycrystalline insulators, it can be used as a versatile and low-cost thermoelectric generator.
16 June 2011 in Physical Review B
The recently discovered spin Seebeck effect (SSE) which generates spin voltage due to a temperature gradient in ferromagnets, was systematically studied in half-metallic Heusler compound (CMS)/Pt thin films to investigate the effect of spin polarization of ferromagnetic layer on SSE. An epitaxial thin film of CMS with an almost perfect 2-ordered structure was prepared directly on a MgO(001) substrate. The measurement was performed at room temperature for various temperature differences, Δ 0–20 K between higher (300 KΔ) and lower (300 K) temperature ends along the film. The clear sign reversal of the thermally induced spin voltage due to SSE at the higher and lower temperature ends of the CMS film was detected by means of inverse spin-Hall effect in a Pt wire. The SSE was also investigated in a Py thin film deposited on a MgO(001) substrate and compared to that with CMS to verify the effect of spin polarization on SSE. Comparable signals of SSE in CMS and Py thin films suggested that thermal excitation of magnons might have more vital effects in SSE than the degree of spin polarization in ferromagnetic metals.