Romy Budhi Widodo

Romy Budhi Widodo

Auto-generated profile, based on publicly available information

Romy Budhi Widodo

Informatics Engineering Study Program, Ma Chung University, Malang, 65151, Indonesia

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 August 2016 in Journal of Sensors
Verified
Journal Article
Open access
PDF file
RWRomy Budhi Widodo
Romy Budhi Widodo
CWChikamune Wada
Chikamune Wada
Attitude estimation is often inaccurate during highly dynamic motion due to the external acceleration. This paper proposes extended Kalman filter-based attitude estimation using a new algorithm to overcome the external acceleration. This algorithm is based on an external acceleration compensation model to be used as a modifying parameter in adjusting the measurement noise covariance matrix of the extended Kalman filter. The experiment was conducted to verify the estimation accuracy, that is, one-axis and multiple axes sensor movement. Five approaches were used to test the estimation of the attitude: (1) the KF-based model without compensating for external acceleration, (2) the proposed KF-based model which employs the external acceleration compensation model, (3) the two-step KF using weighted-based switching approach, (4) the KF-based model which uses thethreshold-basedapproach, and (5) the KF-based model which uses the threshold-based approach combined with a softened part approach. The proposed algorithm showed high effectiveness during the one-axis test. When the testing conditions employed multiple axes, the estimation accuracy increased using the proposed approach and exhibited external acceleration rejection at the right timing. The proposed algorithm has fewer parameters that need to be set at the expense of the sharpness of signal edge transition.

18 February 2019 in Journal of Sensors and Sensor Systems
Verified
Journal Article
Open access
PDF file
RWRomy Budhi Widodo
Romy Budhi Widodo
RQReyna Marsya Quita
Reyna Marsya Quita
RSRhesdyan Setiawan
Rhesdyan Setiawan
CWChikamune Wada
Chikamune Wada
This paper examines the new study of hand orientation as a substitute for computer-mouse movement and is evaluated based on ISO/TS 9241 part 411: Ergonomics of human–system interaction-evaluation methods for the design of physical input devices. Two pairs of hand-orientation candidates were evaluated, using, for example, pitch–roll and pitch–yaw to substitute for up–down and left–right mouse-cursor movements. The up–down cursor movement was generated from the pitch orientation, while the left–right cursor movement was generated from the roll or yaw orientation, depending on the evaluation of the proposed gesture. The research employed a standard computer mouse as a baseline comparison for the study. The empirical study was conducted to evaluate quantitative performance such as throughput and movement time. The best impression resulted when the throughput had the greatest value as well as the shortest movement time. The performance test was based on Fitts's law using a multi-directional tapping test as suggested by ISO/TS 9241-411. The test was divided into several levels of difficulty, including high, medium, low, and very low. The other assessment is qualitative and was performed using the comfort-rating scale questionnaire and rating of perceived exertion of comfortability and fatigue. The quantitative results show that pitch–yaw throughput is slightly higher than for the pitch–roll gesture, and that the movement time in pitch–yaw is slightly less than in pitch–roll, although there is no statistically significant difference between the two. We also found that pitch–yaw movements have a higher level of comfort based on the comfort-rating scale test. Since the test was divided into levels of difficulty, we identified those gestures suitable for the task with a low and very low level of difficulty based on throughput, movement time, and error-rate results. Finally, this study suggests that pitch–roll and pitch–yaw movements of the hand can be used as substitutes for the mouse, and that pitch–yaw movements are superior in regard to causing less fatigue than pitch–roll movements. Furthermore, this study provides a new suggestion for a suitable level of difficulty when using an inertial sensor as an emulator for the movement of a mouse cursor in the field of human–computer interaction.

1 December 2014
Verified
Conference Paper
Closed access
RWRomy Budhi Widodo
Romy Budhi Widodo
HEHiraku Edayoshi
Hiraku Edayoshi
CWChikamune Wada
Chikamune Wada
An attitude and heading reference system that comprises a low-cost inertial measurement unit and a magnetometer is often inaccurate during highly dynamic motion. To mitigate sensor errors, we used a well-known complementary filter. The basic objective in using this filter was to compensate for the drift in the gyro by using the accelerometer and magnetometer as an assistance component. This paper presents the design of an adaptive mechanism to adjust filter gain using a fuzzy logic controller. We hypothesize that dynamic acceleration and change in dynamic acceleration can be used as inputs for the controller. The controller thus produces two adaptive gains for use as filter gains. The experimental result shows that the estimated angle has a good trend until a specific time, i.e., until the influence of the gyro-drift causes estimated angle divergence.

1 December 2013
Verified
Conference Paper
Closed access
RWRomy Budhi Widodo
Romy Budhi Widodo
Takafumi MatsumaruTakafumi Matsumaru
Takafumi Matsumaru
Laser spot clicking technique is the term of remote interaction technique between human and computer using a laser pointer as a pointing device. This paper is focused on the performance test of two laser spot clicking techniques. An off-the-shelf laser pointer has a toggle switch to generate a laser spot, the presence (ON) or absence (OFF) of this spot and its combination are the candidates of the interaction technique. We conducted empirical study that compared remote pointing technique performed using combination of ON and OFF of the laser spot, ON-OFF and ON-OFF-ON, and using a desktop mouse as a baseline comparison. We present quantitative performance test based on Fitts' test using a one-direction tapping test in ISO/TS 9241-411 procedure; and assessment of comfort using a questionnaire. We hope this result give contribution to the interaction technique using laser pointer as a pointing device especially in selecting the appropriate clicking technique for real application. Our results suggest ON-OFF technique has positive advantages over ON-OFF-ON technique such as the throughput and comfort.

1 December 2012
Verified
Conference Paper
Closed access
RWRomy Budhi Widodo
Romy Budhi Widodo
WCWeijen Chen
Weijen Chen
Takafumi MatsumaruTakafumi Matsumaru
Takafumi Matsumaru
A laser pointer can be used as an input interface in human-machine interaction. Such utilization, however, can be problematic and one of the main issues is the lack of good reliability in the laser spotlight detection. Another problem is how to interpret the user's movement of the spotlight into commands for the application. This paper proposes a method for a laser spotlight detection. The aim is to improve the practicality and reliability of the previous approaches. We use the maximum pixel value as a multiplier in determining the threshold. Maximum pixel value is obtained from environment brightness at a specified time. For the second problem we propose a simple interpretation of incidents that allows the user to use the application, with three main events: laser-move, hover, and single-click. There is no need for users and program to wait a specified time span to be able to interact with each other, and the user can directly give commands to the application after the single-click event. These approaches result in better reliability, easier operation of the application by the user, and allow opportunity for development of a system for rehabilitative, recreation, and input interface devices in the future.

1 March 2019 in Journal of Physics: Conference Series
Verified
Conference Paper
Open access
PDF file
RWR B Widodo
R B Widodo
RQR M Quita
R M Quita
SAS Amrizal
S Amrizal
RGR S Gunawan
R S Gunawan
CWChikamune Wada
Chikamune Wada
ESE Setiawan
E Setiawan
Some disabilities caused by sensory malfunction, accident, or congenital disorder could cause people difficulty in grasping the computer mouse. A well-known substitute uses an inertial sensor to monitor the body's orientation. This paper evaluates the efficiency and effectiveness of different methods of holding the sensor. There are two modes of holding the sensor, the grasping mode and the attached mode; we also evaluate a mouse as a baseline. The attached mode works by placing the sensor on the back of user's hand. The quantitative and qualitative evaluation procedure is based on ISO/TS 9241 part 411: Ergonomics of human-system interaction standard. The test consists of four levels of difficulty and indicates that the throughput and task completion times were not statistically different between grasping and attached mode. We also found that grasping mode and attached mode did not show significantly statistical differences in comfort and fatigue based on the questionnaires. The results also suggest that the orientation of the hand used in grasping and attached modes is suitable only for lower-impact computer use.