1 August 2008 in Journal of Physics: Conference Series
29 September 2005 in Physical Review B
We use a displacement-controlled dual double-cantilever-based surface-force-type apparatus to dynamically probe perfluorooctyl trichlorosilane monolayers self-assembled on aluminum and silicon substrates of and rms (root mean square) roughness, respectively, using a diameter ruby sphere of rms roughness. We record stiffness and damping constant as a function of compression load and deconvolute the elastic modulus using contact mechanical formulations. When mechanical intervention is limited to the terminal end of the molecule there is a strong viscous response and a low level of elastic response in consonance with the ability of the molecule to generate conformational defects freely. When the intervention penetrates into the molecular backbone the damping disappears dramatically and the molecule registers at a contact mean pressure of about a monotonic and steep rise in elastic resistance in response to further intervention by the probe. We offer a physical explanation of the process and describe this change as due to a phase transition from a liquidlike to a solidlike state as indicated by a large increase in relaxation time constant.
7 February 2018 in Microsystem Technologies
27 August 2008 in Tribology Letters
12 January 2017 in Journal of Applied Physics
We report the effects of surface modifications on (i) Seebeck coefficients and (ii) flow induced voltage generations of the n-type (n-Si) and p-type (p-Si) silicon wafers. The surfaces of n-Si and p-Si wafers were coated with 1H,1H,2H,2H- perfluorooctyltrichlorosilane (FOTS) molecules. The surface modified n-Si and p-Si of size were mounted on the angle inclined experimental mount, and nitrogen gas was flown over the inclined surface at the subsonic velocities, 5.3, 10.61, 15.91, 21.22, and 26.52 , and the voltage difference between the lead and rear ends of pristine and surface modified n-Si and p-Si was measured. The experimental results and theoretical relations are presented. The flow induced voltage generation is caused by the interplay between the Bernoulli flow and Seebeck effect. The flow-voltage response results show that the half coated and full coated n-Si and p-Si wafers generate more voltage than that of the uncoated at a given velocity. The band theory reveals that the flow of nitrogen gas accumulates charge carriers at the FOTS self assembled monolayer (SAM)—silicon interfaces, which resulted in the more voltage generation by full and half coated ni-Si and p-Si surfaces than that of the pristine surface. The enhanced voltage generations and high sensitivities are caused by an effective increase of the gradient of Fermi Energy (Seebeck coefficient) due to FOTS SAM coatings. Because of that the FOTS SAM modified n-Si and p-Si are become highly sensitive to nitrogen gas flow.
13 November 2018 in Sensors and Actuators A: Physical