Dome-forming volcanoes are among the most hazardous volcanoes on Earth. Magmatic outgassing can be hindered if the permeability of a lava dome is reduced, promoting pore pressure augmentation and explosive behaviour. Laboratory data show that acid-sulphate alteration, common to volcanoes worldwide, can reduce the permeability on the sample lengthscale by up to four orders of magnitude and is the result of pore- and microfracture-filling mineral precipitation. Calculations using these data demonstrate that intense alteration can reduce the equivalent permeability of a dome by two orders of magnitude, which we show using numerical modelling to be sufficient to increase pore pressure. The fragmentation criterion shows that the predicted pore pressure increase is capable of fragmenting the majority of dome-forming materials, thus promoting explosive volcanism. It is crucial that hydrothermal alteration, which develops over months to years, is monitored at dome-forming volcanoes and is incorporated into real-time hazard assessments.

Volcanoes are unstable structures that deform laterally and frequently experience mass wasting events. Hydrothermal alteration is often invoked as a mechanism that contributes significantly to volcano instability. We present a study that combines laboratory experiments, geophysical data, and large‐scale numerical modeling to better understand the influence of alteration on volcano stability, using La Soufrière de Guadeloupe (Eastern Caribbean) as a case study. Laboratory experiments on variably altered (advanced argillic alteration) blocks show that uniaxial compressive strength, Young's modulus, and cohesion decrease as a function of increasing alteration, but that the internal friction angle does not change systematically. Simplified volcano cross sections were prepared (a homogenous volcano, a volcano containing the alteration zone identified by a recent electrical survey, and a volcano with an artificially enlarged area of alteration) and mechanical properties were assigned to zones corresponding to unaltered and altered rock. Numerical modeling performed on these cross sections, using a hydro‐thermo‐mechanical modeling code, show (a) the importance of using upscaled values in large‐scale models and (b) that alteration significantly increases volcano deformation and collapse volume. Finally, we combined published muon tomography data with our laboratory data to create a 3D strength map, exposing a low‐strength zone beneath the southern flank of the volcano coincident with the hydrothermal system. We conclude that hydrothermal alteration decreases volcano stability and thus expedites volcano spreading and increases the likelihood of mass wasting events and associated volcanic hazards. Hydrothermal alteration, and its evolution, should therefore be monitored at active volcanoes worldwide.

Microcracking due to thermal stresses affects the mechanical and flow properties of rocks, which is significant for thermally dynamic environments such as volcanoes and geothermal reservoirs. Compared with other crustal rocks like granite, volcanic rocks have a complex and variable response to temperature; it remains unclear how thermal microcracks form and how they are affected by temperature. We heated and cooled samples of low‐porosity basalts containing different amounts of microcracks and a porous andesite over three cycles, whilst monitoring microstructural changes by acoustic emission (AE) monitoring and measurement of P ‐wave velocity ( v _P ; up to 450°C) and thermal expansion coefficient (TEC; up to 700°C). During the second and third cycles, the TEC was positive throughout and the rate of detected AE was low. In contrast to studies on granite, we measured a strong and reversible increase in v _P with increasing temperature (by 15%–40% at 450°C), which we interpret as due to microcrack closure. During the first cycle, AE and v _P measurements indicated thermal microcracking within the andesite and the basalt with a low initial microcrack density. For these samples, strong inflexions in the TEC indicated stress relaxation during heating, preceding significant thermal microcracking during cooling. The basalt with a high initial microcrack density underwent little microcracking throughout all cycles. Our results and a review of the literature relate the initial microstructure to the occurrence of thermal microcracking and explore the potentially significant influence of temperature on volcanic rock properties.