17 September 2018 in Environmental Science & Technology
A sustainable supply of clean water is essential for the development of modern society, which has become increasingly dependent on desalination technology since 96.5% of the water on Earth is salt water. Thousands of desalination plants are producing massive waste brine as byproduct, and the direct discharge of brine raises serious concerns about its ecological impact. The concept of zero liquid discharge (ZLD) desalination is regarded as the solution, but the current ZLD technologies are hampered by their intensive use of energy and high cost. In this work, a 3D cup shaped solar evaporator was fabricated to achieve ZLD desalination with high energy efficiency via solar distillation. It produces solid salt as the only byproduct and uses sunlight as the only energy source. By rationally separating the light absorbing surface from the salt precipitation surface, the light absorption of the 3D solar evaporator is no longer affected by the salt crust layer as in conventional 2D solar evaporators. Therefore, it can be operated at an extremely high salt concentration of 25 wt % without noticeable water evaporation rate decay in at least 120 h. This new solar evaporator design concept offers a promising technology especially for high salinity brine treatment in desalination plants to achieve greener ZLD desalination as well as for hypersaline industrial wastewater treatment.
25 January 2017 in Chemical Science
The exploration of a facile strategy to synthesize porous ultrathin nanosheets of non-layered materials, especially with exposed reactive facets, as highly efficient electrocatalysts for the hydrogen evolution reaction (HER), remains challenging. Herein we demonstrate a chemical transformation strategy to synthesize porous CoP ultrathin nanosheets with sub-1.1 nm thickness and exposed {200} facets via phosphidation of Co3O4 precursors. The resultant samples exhibit outstanding electrochemical HER performance: a low overpotential (only 56 and 131 mV are required for current densities of 10 and 100 mA cm−2, respectively), a small Tafel slope of 44 mV per decade, a good stability of over 20 h, and a high mass activity of 151 A g−1 at an overpotential of 100 mV. The latter is about 80 times higher than that of CoP nanoparticles. Experimental data and density functional theory calculations reveal that a high proportion of reactive {200} facets, high utilization efficiency of active sites, metallic nature, appropriate structural disorder, facile electron/mass transfer and rich active sites benefiting from the unique ultrathin and porous structure are the key factors for the greatly improved activity. Additionally, this facile chemical conversion strategy can be developed to a generalized method for preparing porous ultrathin nanosheets of CoSe2 and CoS that cannot be obtained using other methods.
20 January 2015 in ACS Applied Materials & Interfaces
6 October 2014 in ACS Nano
16 March 2015 in Angewandte Chemie International Edition
3 July 2013 in Angewandte Chemie International Edition