The fluorescence excitation spectrum of the S1–S0(1B2–1A1) transition in jet‐cooled toluene has been measured up to 2000 cm−1 above the origin band. Dispersed fluorescence spectra of the major features have been recorded and used to assign the levels observed in excitation. Collisional energy transfer experiments have been used to confirm assignments for some of the lower lying S1 fundamentals that were not accessible via direct optical pumping. The number of known S1 fundamentals has been extended to 13. The dispersed fluorescence spectra reveal the onset of intramolecular vibrational energy redistribution (IVR) at low S1 vibrational energies. Fluorescence lifetimes of all of the major bands observed in the excitation spectrum have been measured. The lifetimes decrease from 86 ns for 00 to 48 ns at an S1 vibrational energy of 1900 cm−1. To alleviate the confusion that exists over the mode numbering in toluene a new scheme is proposed which obviates this problem. This system is similar to that used for other substituted aromatics and should rationalize future work.
Lateral slicing of micron length carbon nanotubes (CNTs) is effective on laser irradiation of the materials suspended within dynamic liquid thin films in a microfluidic vortex fluidic device (VFD). The method produces sliced CNTs with minimal defects in the absence of any chemical stabilizers, having broad length distributions centred at ca 190, 160 nm and 171 nm for single, double and multi walled CNTs respectively, as established using atomic force microscopy and supported by small angle neutron scattering solution data. Molecular dynamics simulations on a bent single walled carbon nanotube (SWCNT) with a radius of curvature of order 10 nm results in tearing across the tube upon heating, highlighting the role of shear forces which bend the tube forming strained bonds which are ruptured by the laser irradiation. CNT slicing occurs with the VFD operating in both the confined mode for a finite volume of liquid and continuous flow for scalability purposes.
We demonstrate the power of high resolution, two dimensional laser induced fluorescence (2D-LIF) spectroscopy for observing rovibronic transitions of polyatomic molecules. The technique involves scanning a tunable laser over absorption features in the electronic spectrum while monitoring a segment, in our case 100 cm−1 wide, of the dispersed fluorescence spectrum. 2D-LIF images separate features that overlap in the usual laser induced fluorescence spectrum. The technique is illustrated by application to the S1–S0 transition in fluorobenzene. Images of room temperature samples show that overlap of rotational contours by sequence band structure is minimized with 2D-LIF allowing a much larger range of rotational transitions to be observed and high precision rotational constants to be extracted. A significant advantage of 2D-LIF imaging is that the rotational contours separate into their constituent branches and these can be targeted to determine the three rotational constants individually. The rotational constants determined are an order of magnitude more precise than those extracted from the analysis of the rotational contour and we find the previously determined values to be in error by as much as 5% [G. H. Kirby, Mol. Phys. 19, 289 (1970)10.1080/00268977000101291]. Comparison with earlier ab initio calculations of the S0 and S1 geometries [I. Pugliesi, N. M. Tonge, and M. C. R. Cockett, J. Chem. Phys. 129, 104303 (2008)10.1063/1.2970092] reveals that the CCSD/6–311G** and RI-CC2/def2-TZVPP levels of theory predict the rotational constants, and hence geometries, with comparable accuracy. Two ground state Fermi resonances were identified by the distinctive patterns that such resonances produce in the images. 2D-LIF imaging is demonstrated to be a sensitive method capable of detecting weak spectral features, particularly those that are otherwise hidden beneath stronger bands. The sensitivity is demonstrated by observation of the three isotopomers of fluorobenzene-d1 in natural abundance in an image taken for a supersonically cooled sample. The ability to separate some of the 13C isotopomers in natural abundance is also demonstrated. The equipment required to perform 2D-LIF imaging with sufficient resolution to resolve the rotational features of large polyatomics is available from commercial suppliers.
The methyl rotor dependence of a three state Fermi resonance in S1 toluene at ∼460 cm−1 has been investigated using two-dimensional laser induced fluorescence. An earlier time-resolved study has shown the Fermi resonance levels to have different energy spacings at the two lowest methyl rotor states, m = 0 and 1 [J. A. Davies, A. M. Green, and K. L. Reid, Phys. Chem. Chem. Phys. 12, 9872 (2010)]. The overlapped m = 0 and 1 spectral features have been separated to provide direct spectral evidence for the m dependence of the resonance. The resonance has been probed at m = 3a″1 for the first time and found to be absent, providing further evidence for a large change in the interaction with m. Deperturbing the resonance at m = 0 and 1 reveals that the m dependence arises through differences in the separations of the “zero-order,” locally coupled states. It is shown that this is the result of the local “zero-order” states being perturbed by long-range torsion-vibration coupling that shifts their energy by small amounts. The m dependence of the shifts arises from the Δm = ±3n (n = 1, 2, …) coupling selection rule associated with torsion-rotation coupling in combination with the m2 scaling of the rotor energies, which changes the ΔE for the interaction for each m. There is also an increase in the number of states that can couple to m = 1 compared with m = 0. Consideration of the magnitude of reported torsion-rotation coupling constants suggests that this effect is likely to be pervasive in molecules with methyl rotors.