Khaulah Sulaiman

Khaulah Sulaiman

Auto-generated profile, based on publicly available information

Khaulah Sulaiman

Low Dimensional Materials Research Centre (LDMRC), Department of Physics, Faculty of Science, University of Malaya, 50603 Kuala Lumpur, Malaysia

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 January 2017 in Scientific Reports
Verified
Journal Article
Open access
PDF file
SRSaqib Rafique
Saqib Rafique
SAShahino Mah Abdullah
Shahino Mah Abdullah
MSMuhammad Mehmood Shahid
Muhammad Mehmood Shahid
MAMohammad Omaish Ansari
Mohammad Omaish Ansari
KSKhaulah Sulaiman
Khaulah Sulaiman
This work demonstrates the high performance graphene oxide (GO)/PEDOT:PSS doubled decked hole transport layer (HTL) in the PCDTBT:PC71BM based bulk heterojunction organic photovoltaic device. The devices were tested on merits of their power conversion efficiency (PCE), reproducibility, stability and further compared with the devices with individual GO or PEDOT:PSS HTLs. Solar cells employing GO/PEDOT:PSS HTL yielded a PCE of 4.28% as compared to either of individual GO or PEDOT:PSS HTLs where they demonstrated PCEs of 2.77 and 3.57%, respectively. In case of single GO HTL, an inhomogeneous coating of ITO caused the poor performance whereas PEDOT:PSS is known to be hygroscopic and acidic which upon direct contact with ITO reduced the device performance. The improvement in the photovoltaic performance is mainly ascribed to the increased charge carriers mobility, short circuit current, open circuit voltage, fill factor, and decreased series resistance. The well matched work function of GO and PEDOT:PSS is likely to facilitate the charge transportation and an overall reduction in the series resistance. Moreover, GO could effectively block the electrons due to its large band-gap of ~3.6 eV, leading to an increased shunt resistance. In addition, we also observed the improvement in the reproducibility and stability.

16 May 2016 in RSC Advances
Verified
Journal Article
Closed access
PDF file
SRSaqib Rafique
Saqib Rafique
SAShahino Mah Abdullah
Shahino Mah Abdullah
WMWaleed E. Mahmoud
Waleed E. Mahmoud
AAAttieh A. Al-Ghamdi
Attieh A. Al-Ghamdi
KSKhaulah Sulaiman
Khaulah Sulaiman
The synthesis of vanadium pentaoxide (V 2 O 5 ) nanoparticles by a hydrothermal method and their utilization in a PEDOT:PSS buffer layer in a PCDTBT:PC 71 BM device structure is demonstrated.

14 March 2013 in Sensors
Verified
Journal Article
Open access
PDF file
ZAZubair Ahmad
Zubair Ahmad
QZQayyum Zafar
Qayyum Zafar
KSKhaulah Sulaiman
Khaulah Sulaiman
RARizwan Akram
Rizwan Akram
KKKhasan S. Karimov
Khasan S. Karimov
In this paper, we present the effect of varying humidity levels on the electrical parameters and the multi frequency response of the electrical parameters of an organic-inorganic composite (PEPC+NiPc+Cu2O)-based humidity sensor. Silver thin films (thickness ~200 nm) were primarily deposited on plasma cleaned glass substrates by the physical vapor deposition (PVD) technique. A pair of rectangular silver electrodes was formed by patterning silver film through standard optical lithography technique. An active layer of organic-inorganic composite for humidity sensing was later spun coated to cover the separation between the silver electrodes. The electrical characterization of the sensor was performed as a function of relative humidity levels and frequency of the AC input signal. The sensor showed reversible changes in its capacitance with variations in humidity level. The maximum sensitivity ~31.6 pF/%RH at 100 Hz in capacitive mode of operation has been attained. The aim of this study was to increase the sensitivity of the previously reported humidity sensors using PEPC and NiPc, which has been successfully achieved.

1 December 2009 in Materials Letters
Verified
Journal Article
Closed access
MYM.N. Yusli
M.N. Yusli
TYT. Way Yun
T. Way Yun
KSK. Sulaiman
K. Sulaiman

15 September 2015 in Journal of Nanoparticle Research
Verified
Journal Article
Closed access
PDF file
QZQayyum Zafar
Qayyum Zafar
MNMansoor Ani Najeeb
Mansoor Ani Najeeb
ZAZubair Ahmad
Zubair Ahmad
KSKhaulah Sulaiman
Khaulah Sulaiman

4 June 2014 in Sensors
Verified
Journal Article
Open access
PDF file
SAShahino Mah Abdullah
Shahino Mah Abdullah
ZAZubair Ahmad
Zubair Ahmad
KSKhaulah Sulaiman
Khaulah Sulaiman
An electrochemical cell using an organic compound, copper (II) phthalocyanine-tetrasulfonic acid tetrasodium salt (CuTsPc,) has been fabricated and investigated as a solution-based temperature sensor. The capacitance and resistance of the ITO/CuTsPc solution/ITO chemical cell has been characterized as a function of temperature in the temperature range of 25–80 °C. A linear response with minimal hysteresis is observed. The fabricated temperature sensor has shown high consistency and sensitive response towards a specific range of temperature values.