6 November 2009 in IEEE Journal of Selected Topics in Quantum Electronics
We present a summary of our recent experiments showing how various nonlinear phenomena are enhanced due to slow light in silicon photonic crystal waveguides. These nonlinear processes include self-phase modulation (SPM), two-photon absorption (TPA), free-carrier related effects, and third-harmonic generation, the last effect being associated with the emission of green visible light, an unexpected phenomenon in silicon. These demonstrations exploit photonic crystal waveguides engineered to support slow modes with a range of group velocities as low as c/50 and, more crucially, with significantly reduced dispersion. We discuss the potential of slow light in photonic crystals for realizing compact nonlinear devices operating at low powers. In particular, we consider the application of SPM to all-optical regeneration, and experimentally investigate an original approach, where enhanced TPA and free-carrier absorption are used for partial regeneration of a high-bit rate data stream (10 Gb/s).
18 July 2017 in Optics Express
Optical frequency comb lines with poor carrier to noise ratio (CNR) are significantly improved by Brillouin amplification using its extreme narrow bandwidth gain to suppress out of band noise, enabling higher quality signal modulation. Its application to spectral lines of narrow 10 GHz pitch and poor CNR is shown to suppress the otherwise strong phase distortion caused by poor CNR after encoding with 96 Gb/s DP-64-QAM signals and restore the bit error rate (BER) to below the limit for standard forward error correction (FEC). This is also achieved with the required frequency shifted optical pump for amplification obtained by seeding it from the comb itself, sparing the need for lasers and frequency locking. Simultaneous CNR improvement for 38 comb lines is also achieved with BER restored to below the FEC limit, enabled by a multi-line pump that is pre-dispersed to suppress its spectral distortion from the Kerr effect in the gain medium. Carrier performance at minimum BER shows minimal noise impact from the Brillouin amplifier itself. The results highlight the unique advantage of Brillouin gain for phase sensitive communications in transforming otherwise noisy spectral lines into useful high quality signal carriers.
19 May 2009 in Optics Express
We report the first demonstration of the use of an RF spectrum analyser with multi-terahertz bandwidth to measure the properties of femtosecond optical pulses. A low distortion and broad measurement bandwidth of 2.78 THz (nearly two orders of magnitude greater than conventional opto-electronic analyzers) was achieved by using a 6 cm long As2S3 chalcogenide waveguide designed for high Kerr nonlinearity and near zero dispersion. Measurements of pulses as short as 260 fs produced from a soliton-effect compressor reveal features not evident from the pulse’s optical spectrum. We also applied an inverse Fourier transform numerically to the captured data to re-construct a time-domain waveform that resembled pulse measurement obtained from intensity autocorrelation.
22 March 2012 in Optics Express
We demonstrate a nonlinear signal processing approach for compensating nonlinear distortion caused by the Kerr effect in optical fiber transmission. The concept relies on propagating the signal through a separate all-optical module outside the link to apply tunable nonlinear distortion and phase-conjugation in series. We show this uniquely enables tunable regeneration of phase-encoded 40 Gb/s signals of different data-formats and number of WDM channels, to allow significantly higher transmission powers through single and multi-span fiber links. An improvement in the receiver power penalty by 3~4 dB for a bit-error-rate (BER) of ≈10−5 is achieved.
6 December 2010 in Optics Express
We report the first demonstration of optical phase conjugation (OPC) transmission of phase encoded and wavelength-division multiplexed (WDM) signals by the Kerr effect in a planar structured waveguide. The phase conjugated electric field of the signal is produced by four wave mixing pumped by a CW laser during co-propagating with the signal in a highly nonlinear waveguide fabricated in As2S3 glass. Experiments demonstrate the capability of the device to perform dispersion-free transmission through up to 225 km of standard single mode fiber for a 3 × 40 Gb/s WDM signal, with its channels encoded as return-to-zero differential phase shift keying and spaced either 100 or 200 GHz apart. This work represents an important milestone towards demonstrating advanced signal processing of high-speed and broadband optical signals in compact planar waveguides, with the potential for monolithic optical integration.
2 November 2017 in IEEE Journal of Selected Topics in Quantum Electronics
An active, harmonically modelocked fiber laser with phase unstable output pulses from its long cavity is shown transformable into a low noise frequency comb suited for phase noise sensitive communications. Cross phase modulation (XPM) of its output pulses with a CW probe laser in a highly nonlinear fiber (HNLF) produces a frequency comb with noise at its minimum for low timing jitter pulses. Experiments with 2 ps pulses at 40 GHz repetition show spectral lines obtained from within a bandwidth of 30 lines achieve low bit error rate (BER) after their individual modulation with 96 Gb/s DP 64-QAM signals, reaching below the limit of hard-decision forward error correction (FEC), and close to that of a narrow linewidth CW laser. Its suitability as a seed for even broader comb generation is demonstrated by addition of a second stage HNLF, enabling a larger bandwidth of nearly 50-comb lines to reach a BER below the FEC limit for the same signal. The benefit of XPM for improving the phase noise of a modelocked semiconductor laser frequency comb is also shown, with limitation from larger pulse timing jitter. The results highlight the capability for enabling new applications of otherwise unusable pulse sources.