A finite-band noise model for degenerate four-wave mixing (FWM) including channel walk-off in return-to-zero on-off-keying (RZ-OOK) transmission is extended to include nondegenerate FWM (ND-FWM). The model is verified by comparing the results for the noise variance for each type of FWM to split-step-Fourier (SSF) simulations for a 10-Gb/s single span link, and excellent agreement is obtained. A physical interpretation of the walk-off effect on the FWM noise is formulated in terms of intracollision and intercollision interference of the corresponding generated FWM waves. The author shows that the walk-off effect modifies the FWM noise power spectral density only at high frequencies by producing distinct peaks at locations determined by the channel spacing. In principle, the walk-off effect significantly increases the noise variance for both types of FWM before any filtering at the end of fiber. Upon demultiplexing, it is found that the walk-off effect is significant and observable for the degenerate FWM case but is no longer significant for the ND-FWM case. When a sub-bit-rate electrical filter is used in the receiver, the walk-off effect becomes insignificant for all types of FWM. They systematically conclude that the walk-off effect is unimportant for FWM in typical RZ-OOK systems when tight electrical filtering is used. They also illustrate the accuracy of the model for the more general case where more than one FWM tone is coincident on a probe channel by comparing the analytic model to SSF simulations for a five-channel example
Disposal of contaminated wastewater causes many serious problems especially when it gets mixed with the ground and seawater. It is, therefore, important to apply any remedial action to eradicate dangerous pollutants from the aqueous effluents and to avoid exposure of this wastewater to aquatic life. The research results discussed herein deal with the removal of Rhodamine B (RhB) and Congo Red (CR) dye from wastewater by using multi-walled carbon nanotubes (MWCNTs) as an adsorbent. Different factors like solid dosage, initial pH and concentration, time, and temperature were studied to understand the behavior and mechanism of adsorption. The maximum adsorption capacity in case of a single component system was found to be 302 mg/g and 300 mg/g for Congo Red and Rhodamine B, respectively. Moreover, the mechanism of adsorption was best described by a pseudo-second-order kinetic model. Thermodynamic parameters showed that adsorption of CR and RhB was exothermic when these were removed from a single dye system. However, the overall process became endothermic for concurrent removal of both dyes from the solution. The research results showed that the MWCNTs could successfully be utilized to remove the dye from the industrial wastewater.
9 July 2026 in International Journal of Hydrogen Energy