Icing of wind turbines happens occasionally at different latitudes and locations in the world and consequently affects the wind turbine fatigue loads. Large ice accretion may cause wind turbine vibration due to uneven ice shedding, which could lead to structural failures in addition to hazardous issues accompanied with ice being shed off wind turbine blades. In this paper, a review study of the effects of ice accretion on the structural behavior of the wind turbines is presented.
This research investigates the essential role of cooling systems in optimizing the performance of photovoltaic panels, particularly in hot climates. Elevated temperatures on the back surface of photovoltaic panels pose a challenge, potentially reducing electrical output and overall efficiency. To address this, a cooling system employing water spray and air was proposed and examined across three scenarios. Results show a consistent reduction in panel temperature with the implemented cooling systems. The drop in temperature of 24 °C (40%) and increase in the output power of 13% indicates its effectiveness, with peak efficiency observed during high ambient temperatures. When water cooling was used, the percentage drop in temperature ranged from approximately 20.5% to 35.4%. The air-cooling system achieves a percentage drop in temperature, ranging from approximately 6 to 26%. Hybrid cooling proves most effective in substantially reducing panel temperature compared to water or air alone. A detailed examination of output power reveals consistent and significant increases with cooling throughout the day. A significant higher percentage power increase is achieved during peak solar radiation hours highlighting the effectiveness of the system during intense sunlight exposure. The cumulative effect reinforces the practical significance of the cooling system, showing its potential to enhance daily energy yield. Efficiency trends consistently indicate higher efficiency with cooling compared to without cooling. The hybrid system, which appears as a promising solution for diverse environmental conditions cases, improves the overall efficiency by up to 2%.
Wind energy is a promising way in the middle of growing demand for clean energy in high north, where atmospheric icing is a hazard for safe operations of wind turbines. In this research work, the vibrational effects due to atmospheric ice accretion on a multi megawatt large wind turbine are numerically investigated using a finite element based approach. Three different icing scenarios were addressed and accreted on-blade ice mass was calculated analytically based upon ISO 95214 standards. Special attentions are given to the first natural frequency of the wind turbine blade and its interaction when the exciting frequency approaches the natural frequency of the wind turbine tower. Results show variations of natural frequencies due to different accreted icing loads scenarios, which may have different implications to the integrity of the structure.
Continuous structures such as beams, rods and plates can be modelled by discrete mass and stiffness parameters and analysed as multi-degree-of-freedom systems. The analysis of structural vibration is necessary to obtain the natural frequencies of a structure and the response to the external excitation. In this way, it can be determined whether a particular structure will fulfil its intended function and, in addition, the results of the dynamic loadings acting on a structure can be predicted. The lack of a sober analytical research about the vibrational behaviour of the 5-MW wind turbine blade pushed us to investigate about this crucial issue, however, most of the discreet researches are concerned with the aerodynamic effects rather than structural analysis. In this article, Rayleigh–Ritz method was implemented for a typical 5-MW wind turbine blade. MATLAB codes were developed and natural frequencies were obtained for both flapwise and edgewise vibrational behaviour. A good agreement was observed between the analytical results and the manufacturer results.