Naboneeta Sarkar

Naboneeta Sarkar

Auto-generated profile, based on publicly available information

Naboneeta Sarkar

W. M. Keck Biomedical Materials Research Laboratory, School of Mechanical and Materials Engineering, Washington State University, Pullman, Washington 99164, United States

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2019 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
NSNaboneeta Sarkar
Naboneeta Sarkar
SBSusmita Bose
Susmita Bose


28 February 2021 in Acta Biomaterialia
Verified
Journal Article
Closed access
SBSusmita Bose
Susmita Bose
NSNaboneeta Sarkar
Naboneeta Sarkar
DBDishary Banerjee
Dishary Banerjee


11 December 2021 in Biomaterials
Verified
Journal Article
Open access
AFAshley L. Farris
Ashley L. Farris
DLDennis Lambrechts
Dennis Lambrechts
YZYuxiao Zhou
Yuxiao Zhou
NZNicholas Y. Zhang
Nicholas Y. Zhang
NSNaboneeta Sarkar
Naboneeta Sarkar
WGWarren L. Grayson
Warren L. Grayson
Low oxygen (O2) diffusion into large tissue engineered scaffolds hinders the therapeutic efficacy of transplanted cells. To overcome this, we previously studied hollow, hyperbarically-loaded microtanks (μtanks) to serve as O2 reservoirs. To adapt these for bone regeneration, we fabricated biodegradable μtanks from polyvinyl alcohol and poly(lactic-co-glycolic acid) and embedded them to form 3D-printed, porous poly-ε-caprolactone (PCL)-μtank scaffolds. PCL-μtank scaffolds were loaded with pure O2 at 300 – 500 psi. When placed at atmospheric pressures, the scaffolds released O2 over a period of up to 8 hours. We confirmed the inhibitory effects of hypoxia on the osteogenic differentiation of human adipose-derived stem cells (hASCs and we validated that μtank-mediated transient hyperoxia had no toxic impacts on hASCs, possibly due to upregulation of endogenous antioxidant regulator genes. We assessed bone regeneration in vivo by implanting O2-loaded, hASC-seeded, PCL-μtank scaffolds into murine calvarial defects (4 mm diameters × 0.6 mm height) and subcutaneously (4 mm diameter × 8 mm height). In both cases we observed increased deposition of extracellular matrix in the O2 delivery group along with greater osteopontin coverages and higher mineral deposition. This study provides evidence that even short-term O2 delivery from PCL-μtank scaffolds may enhance hASC-mediated bone tissue regeneration.

16 June 2017 in Journal of Advanced Ceramics
Verified
Journal Article
Open access
PDF file
BBBijay Basnet
Bijay Basnet
NSNaboneeta Sarkar
Naboneeta Sarkar
JPJung Gyu Park
Jung Gyu Park
SMSangram Mazumder
Sangram Mazumder
IKIk Jin Kim
Ik Jin Kim
The porous ceramics based on Al2O3–TiO2/ZrO2–SiO2 from particle-stabilized wet foam by direct foaming were discussed. The initial Al2O3–TiO2 suspension was prepared by adding TiO2 suspension to partially hydrophobized colloidal Al2O3 suspension with equimolar amount, to form Al2TiO5 on sintering. The secondary ZrO2–SiO2 suspension was prepared using the equimolar composition, and to obtain ZrSiO4, ZrTiO4, and mullite phases in the sintered samples, the secondary suspension was blended into the initial suspension at 0, 10, 20, 30, and 50 vol%. The wet foam exhibited an air content up to 87%, Laplace pressure from 1.38 to 2.23 mPa, and higher adsorption free energy at the interface of approximately 5.8×108 to 7.5×108 J resulting an outstanding foam stability of 87%. The final suspension was foamed, and the wet foam was sintered from 1400 to 1600 °C for 1 h. The porous ceramics with pore size from 150 to 400 μm on average were obtained. The phase identification was accomplished using X-ray diffraction (XRD), differential thermal analysis (DTA), and thermogravimetric analysis (TGA), and microstructural analysis was performed using field emission scanning electron microscopy (FESEM).