The selective removal of nitrogen-containing compounds from oil and oil fractions is of interest because of the potential deleterious impact of such compounds on products and processes. Problems caused by nitrogen-containing compounds include gum formation, acid catalyst inhibition and deactivation, acid–base pair-related corrosion, and metal complexation. A brief overview of the classes of nitrogen compounds found in oil is provided. The review of processes to remove nitrogen from oil emphasizes studies that investigated denitrogenation of industrial feedstocks, such as refinery fractions, heavy oils, and bitumens. The main topics covered are hydrotreating, liquid–liquid phase partitioning, solvent deasphalting, adsorption, chemical conversion followed by separation, and microbial conversion. Chemical conversion processes include oxidative denitrogenation, N-alkylation, complexation with metal salts, and conversion in high-temperature water. There are many processes for denitrogenation by separation of the nitrogen-rich products from oil without removing the nitrogen group from the nitrogen-containing compounds. As a consequence, most of these processes are viable mainly for removal of nitrogen from low-nitrogen-content oils, typically with <0.1 wt % N. At present, hydrodenitrogenation appears to be the only industrially viable process for nitrogen removal from oils with high nitrogen content.
1 April 2011 in The Journal of Supercritical Fluids
The reactivity and reactions of asphaltenes were explored over the temperature range 100–250 °C following reports of reactivity and meaningful free radical content in asphaltenes. This study employed industrial pentane precipitated asphaltenes from Athabasca oilsands bitumen. The presence of free radicals in the asphaltenes feed was confirmed. On heating the asphaltenes to 150 °C, the aromatic hydrogen content increased relative to the feed by a factor 1.12. It was also found that on heating the asphaltenes to 150 °C the n-heptane insoluble fraction increased from 67% to 75%. Almost no gas phase products were produced. The observed changes were ascribed to hydrogen transfer reactions and addition products formed by combination reactions. Direct evidence of hydrogen transfer reactions taking place in the asphaltenes was obtained through the use of the model systems, α-methylstyrene and cumene, as well as anthracene and 9,10-dihydroanthracene. The extent of hydrogen transfer was of the order 1.8 mg H/g asphaltenes in 1 h at 250 °C. Asphaltenes also caused dimerization of model compounds, providing indirect evidence that free radical combination reactions took place in the asphaltenes. Interpretation relying on thermodynamic arguments combined with experimental results indicated that at 250 °C the reactive species in asphaltenes were incapable of abstracting hydrogen by hydrogen transfer that had bond strengths (based on homolytic bond dissociation energy) exceeding around 353 kJ mol–1. Using similar arguments, it was deduced that the ratio of reactive species in asphaltenes capable of abstracting hydrogen with bond strengths in the range around 315–353 kJ mol–1, compared to transferable hydrogen in asphaltenes with a bond strength less than 315 kJ mol–1 was about 2:1.