1 October 2014 in Food Research International
1 July 2016 in Food Chemistry
1 December 2016 in Food Research International
1 March 2020 in Food Research International
The relevance of an appropriate nutrition requires innovation in the design of food ingredients. The goal of this work was to obtain a powdered extract of quinoa by using spray-drying. To this aim, quinoa flour was suspended in water to obtain a soluble fraction mainly composed of proteins, starch, fiber, lipids, antioxidants and minerals. The spray-drying conditions of this quinoa soluble fraction were set-up in terms of inlet temperatures (150, 160, 170 and 180 °C) and feed flow (4.5, 7.5, 10.5 mL/min). The obtained powders were characterized by determining the proximate composition, antioxidant activity, microstructure, fatty acids' profile, and starch and proteins' structures. A correlation among the drying parameters and the chemical and functional attributes of the powders was addressed using principal component analysis. From a technological viewpoint the use of moderate feed flows (7.5 mL/min) and high inlet temperatures (180 °C) was the best combination to obtain high powder yields (85% d.b.), low aw (0.047 ± 0.005) and high solids content (0.956 ± 0.005). The drying temperature positively affected the structure of starch, improving swelling and favoring moderate agglomeration which increases the encapsulation properties of quinoa. These results support the use of spray-drying as a suitable method to obtain powdered extracts of quinoa without affecting the nutritional value, thus supporting their use as functional ingredients in the formulation of ready-to-eat foods.
1 November 2018 in Food Research International
1 July 2018 in Food Research International
CACuauhtémoc Araujo-Andrade
Cuauhtémoc Araujo-Andrade
Two types of inulins of different composition were investigated in the glassy and in the crystalline states, at relative humidities within 11 and 97%. The melting and glass transition temperatures (Tm, Tg), and their crystallinity indexes (CI) were determined by modulated differential-scanning calorimetry (MDSC) and wide-angle X-ray scattering (WAXS), respectively. In parallel assays, Fourier transform-infrared spectroscopy (FTIR) coupled to principal component analysis (PCA) enabled a physical-chemical and structural characterization of samples, explaining 90% of the total variance. Finally, partial least square (PLS) models were defined to determine Tg, Tm, and CI directly from the FTIR spectra, using the MDSC and WAXS results as reference methods. In all cases, the mean of predicted values fitted very well those of the reference methods (R2 > 0.961), thus supporting the use of the PLS models to investigate unknown samples. The robustness of the models underlines the usefulness of FTIR to easily determine physical-chemical parameters, otherwise requiring complex preparation of samples and prolonged times of analysis.