The triboelectric effect, charge transfer during sliding, is well established but the thermodynamic driver is not well understood. We hypothesize here that flexoelectric potential differences induced by inhomogeneous strains at nanoscale asperities drive tribocharge separation. Modeling single asperity elastic contacts suggests that nanoscale flexoelectric potential differences of or larger arise during indentation and pull-off. This hypothesis agrees with several experimental observations, including bipolar charging during stick slip, inhomogeneous tribocharge patterns, charging between similar materials, and surface charge density measurements.
We report experimental values for the flexoelectric responses of , and single crystals using a three-point bending approach. We find all samples possess a linear flexoelectric response with effective short-circuit flexoelectric coefficients . Flexocoupling voltages computed from these measured effective flexoelectric coefficients are found to significantly vary across the investigated materials and refute the previous suggestions that they should be V. Importantly, we find that low dielectric constant materials can have large flexocoupling voltages exceeding nominal expectations.
We develop the relationship between the strain derivative of the mean-inner potential and surface contributions to flexoelectricity, identifying the true surface-specific component of the flexoelectric response of finite samples. Density functional theory calculations on a range of experimentally observed, low energy SrTiO3, MgO, and Si surfaces demonstrate that the mean-inner potential and its contributions to flexoelectricity are sensitive to small differences in surface structure, chemistry, and adsorbates. We also introduce a method to estimate mean-inner potential contributions to flexoelectricity using electron scattering factors and use this approximation to predict total flexoelectric responses for a variety of insulators. Strategies to experimentally disentangle bulk and surface flexoelectric terms are also discussed.
X-ray photoelectron spectroscopy, ultraviolet photoelectron spectroscopy, and density functional theory calculations were used to study the electronic structure of three lanthanide scandates: , and . X-ray photoelectron spectra simulated from first-principles calculations using a combination of on-site hybrid and methods were found to be in good agreement with experimental x-ray photoelectron spectra. The hybrid method was used to model the ground state electronic structure and the method accounted for the shift of valence state energies due to photoelectron emission via a Slater-Janak transition state approach. From these results, the lanthanide scandate valence bands were determined to be composed of , and states, in agreement with previous work. However, contrary to previous work the minority states were found to be located closer to, and in some cases at, the valence band maximum. This suggests that minority electrons may play a larger role in lanthanide scandate properties than previously thought.