Francisco Sagasta

Francisco Sagasta

Auto-generated profile, based on publicly available information

Francisco Sagasta

Univ Granada, Dept Appl Phys, Campus Fuentenueva, E-18071 Granada, Spain

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 August 2015 in Mechanical Systems and Signal Processing
Verified
Journal Article
Closed access
MZMiguel E. Zitto
Miguel E. Zitto
RPRosa Piotrkowski
Rosa Piotrkowski
AGAntolino Gallego
Antolino Gallego
FSFrancisco Sagasta
Francisco Sagasta
Amadeo Benavent-ClimentAmadeo Benavent-Climent
Amadeo Benavent-Climent

16 March 2016 in Applied Sciences
Verified
Journal Article
Open access
PDF file
FSFrancisco Sagasta
Francisco Sagasta
Amadeo Benavent-ClimentAmadeo Benavent-Climent
Amadeo Benavent-Climent
AAAndrés Roldán Aranda
Andrés Roldán Aranda
AGAntolino Gallego
Antolino Gallego
This paper presents a comparison of the acoustic emission (AE) energy and the plastic strain energy released by some reinforced concrete (RC) specimens subjected to cyclic or seismic loadings. AE energy is calculated, after proper filtering procedures, using the signals recorded by several AE low frequency sensors (25–100 kHz) attached on the specimens. Plastic strain energy is obtained by integrating the load displacement curves drawn from the measurements recorded during the test. Presented are the results obtained for: (i) two beams (with and without an artificial notch) and a beam-column connection subjected to several cycles of imposed flexural deformations; (ii) a reinforced concrete slab supported by four steel columns, and a reinforced concrete frame structure, both of the latter are subjected to seismic simulations with a uniaxial shaking table. The main contribution of this paper, which is a review of some papers previously published by the authors, is to highlight that, in all cases, a very good correlation is found between AE energy and plastic strain energy, until the onset of yielding in the reinforcing steel. After yielding, the AE energy is consistently lower than the plastic strain energy. The reason is that the plastic strain energy is the sum of the contribution of concrete and steel, while the AE energy acquired with thresholds higher than 35 dBAE captures only the contribution of the concrete cracking, not the steel plastic deformation. This good correlation between the two energies before the yielding point also lends credibility to the use of AE energy as a parameter for concrete damage evaluation in the context of structural health monitoring.

22 August 2014 in Journal of Nondestructive Evaluation
Verified
Journal Article
Open access
PDF file
FSFrancisco Sagasta
Francisco Sagasta
Amadeo Benavent-ClimentAmadeo Benavent-Climent
Amadeo Benavent-Climent
TFTomás Fernández-Quirante
Tomás Fernández-Quirante
AGAntolino Gallego
Antolino Gallego
This paper presents analysis and discussion of the \(b\) - and ib-values calculated from the acoustic emission (AE) signals recorded during dynamic shake-table tests conducted on a reinforced concrete (RC) frame subjected to several uniaxial seismic simulations of increasing intensity until collapse. The intensity of shaking was controlled by the peak acceleration applied to the shake-table in each seismic simulation, and it ranged from 0.08 to 0.47 times the acceleration of gravity. The numerous spurious signals not related to concrete damage that inevitably contaminate AE measurements obtained from complex dynamic shake-table tests were properly filtered with an RMS filter and the use of guard sensors. Comparing the \(b\) - and ib-values calculated through the tests with the actual level of macro-cracking and damage observed during testing, it was concluded that the limit value of 0.05 proposed in previous research to determine the onset of macro-cracks should be revised in the case of earthquake-type dynamic loading. Finally, the \(b\) - and ib-values were compared with the damage endured by the RC frame evaluated both visually and quantitatively in terms of the inter-story drift index.

1 September 2013 in Archives of Acoustics
Verified
Journal Article
Open access
PDF file
FSFrancisco A. Sagasta
Francisco A. Sagasta
JTJuan L. Torné
Juan L. Torné
ASAntonio Sánchez-Parejo
Antonio Sánchez-Parejo
AGAntolino Gallego
Antolino Gallego
The purpose of this work is to distinguish between Acoustic Emission (AE) signals coming from mechanical friction and AE signals coming from concrete cracking, recorded during fourteen seismic simulations conducted with the shaking table of the University of Granada on a reinforced concrete slab supported on four steel columns. To this end, a particular criterion is established based on the Root Mean Square of the AE waveforms calculated in two different temporal windows. This criterion includes a parameter calculated by optimizing the correlation between the mechanical energy dissipated by the specimen (calculated by means of measurements with accelerometers and displacement transducers) and the energy obtained from the AE signals recorded by low-frequency piezoelectric sensors located on the specimen. The final goal of this project, initiated four years ago, is to provide a reliable evaluation of the level of damage of Reinforced Concrete specimens by means of AE signals to be used in future Structural Health Monitoring strategies involving RC structures.