PhD student, Department of Civil Engineering, University of Aveiro, and Research Fellow, Department of Civil Engineering, Faculty of Engineering, University of Porto, Campus Universitario de Santiago, 3810-193 Aveiro, Portugal, Telephone: +351 234 370 049, Telefax: +351 370 094,or
Auto-generated profile, based on publicly available information
A. Rosete
PhD student, Department of Civil Engineering, University of Aveiro, and Research Fellow, Department of Civil Engineering, Faculty of Engineering, University of Porto, Campus Universitario de Santiago, 3810-193 Aveiro, Portugal, Telephone: +351 234 370 049, Telefax: +351 370 094,or
Installation damage of geosynthetics occurs during their handling, positioning on the ground and the placing and compacting of fill material. Abrasion is a common damage mechanism where there is cyclic relative motion (friction) between a geosynthetic and contact soil. This paper presents the laboratory test results of mechanical damage and abrasion performed on six geosynthetics. The in isolation and combined effects on mechanical, hydraulic and physical properties of the geosynthetics were assessed. Results show that the effects of induced mechanical and abrasion damage essentially depend on the geosynthetic structure. For the most affected materials, strength losses after abrasion (in isolation and combined with mechanical damage) are higher than after the induced mechanical damage. Therefore, for most geosynthetics studied, abrasion is the conditioning mechanism which most affects their tensile strength. An increase of the characteristic opening size of the geosynthetics was observed, while their permittivity did not increase. This may be caused by differences in the test set-ups.