Department of Physics, Faculty of Mathematics and Natural Sciences, Universitas Negeri Malang (State University of Malang), Jl. Semarang No. 5, Malang 65145, Indonesia
Auto-generated profile, based on publicly available information
Abdulloh Fuad
Department of Physics, Faculty of Mathematics and Natural Sciences, Universitas Negeri Malang (State University of Malang), Jl. Semarang No. 5, Malang 65145, Indonesia
The aim of this research is to synthesize nanoparticles of black pigment of Magnetite ( Fe 3 O 4 ), red pigment of hematite (α- Fe 2 O 3 ), and yellow pigment of ghoetite (α-FeOOH) from the iron sand. The black pigment of Fe 3 O 4 and the yellow pigment α-FeOOH nanoparticles were synthesized by coprecipitation method with variation of pH. Whereas, the red pigment Fe 2 O 3 was sythesized by sintering Fe 3 O 4 nanoparticles at temperature between 400 °C and 700 7°C for 1 hour. All the pigments has been characterized using X-ray diffraction and SEM. The XRD results shown that the particle size of the black pigmen Fe 3 O 4 , red pigment Fe 3 O 4 and yellow pigment α-FeOOH are around 12, 32, and 30 nm repectively. The particle size of Fe 2 O 3 nanoparticles increase by increasing sintering temperature from 32 nm at 400 °C to 39 nm at 700 °C. For yellow pigment of α-FeOOH, the particle size increase by increasing pH from 30,54 nm at pH 4 to 48,60 nm at pH 7. The SEM results shown that the morphologies of black, yellow and red pigments are aglomarated.
Simple coprecipitation method has been used to produce nanoparticles of MgO (magnesia), (spinel), (yttria) and (ferrite). The raw materials were, in respective, magnesium powder, magnesium and aluminium powders, ytrria powder, and natural sand. The coprecipitation included the use of suitable acid and base to dissolve the powders or sand and to produce precipitates, as well as the use of water to wash and purify the precipitates, and drying at relatively low temperatures, namely lower than 100° C, followed by heating at 450° C, 750° C, 600° C and 200° C to produce magnesia, spinel, yttria and ferrite nanopowders, respectively. X‐ray diffractometry was used to characterise the purity and nanocrystallinity of the final powders. It was found qualitatively that the powders were of high purity. Further line‐broadening analysis using single‐line and Rietveld‐based softwares was performed to reveal the nanocrystallinity of the powders. Different line breadth values were found for the powders, indicating different crystallite sizes. It was also found that, particularly for spinel and yttria, the diffraction peaks exhibited ‘longer’ tails, indicating broader crystallite size distribution. The average crystallite size for the powders ranged from 3 to 70 nm. The results could then be used as ‘fingerprints’ for nanocrystallinity using x‐ray diffractometry. The XRD crystallite sizes for yttria and ferrite nanocrystals are in fair agreement with their counterparts from electron microscopy observation.
We report on the effect of the morphological modification on optical properties and polarization of ZnO nanorods (NR). Here, the morphology and structure of the ZnO NR were modified by introducing different annealing temperatures. The increase of length and diameter and change in density of the ZnO NR were clearly observed by increasing the annealing temperature. We found that the samples show different oxygen vacancy (VO) and zinc interstitial (ZnI) concentrations. We suggest that the different concentrations of VO and ZnI are originated from morphological and structural modification. Our results reveal that optical absorption and polarization of ZnO NR could be enhanced by producing a high concentration of VO and ZnI. The modification of VO and ZnI promotes a decrease in the band gap and coexistence of high optical absorption and polarization in our ZnO NR. Our findings would give a broad insight into the morphological modification and characterization technique on ZnO NR. The high optical and polarization characteristics of ZnO NR are potential for developing the high-performance nanogenerator device for multitype energy harvesting.
1 May 2017 in Journal of Physics: Conference Series
TiO 2 is one of semiconductor materials which are widely used as photocatalyst in the form of a thin film. The TiO 2 thin film is prepared by using the spin coating sol-gel method. The researcher prepared TiO 2 thin film with 3 coating variations and X-Ray Diffraction characterization, UV-Vis Spectrophotometer, Electron Microscopy Scanning, and examined its hydrophilic and anti-fogging properties. The result of X-Ray Diffraction showed that the phase formed is the anatase on 101crystal field. The Electron Microscopy Scanning images showed that TiO 2 thin films had a homogeneous surface with the particle sizes as big as 235 nm, 179 nm, and 137 nm. The thickness of each thin film was 2.06 m , 3.33 m , and 5.20 m . The characterization of UV-Vis Spectrophotometer showed that the greatest absorption to the wavelength of visible light was in the thin film's thickness of 3 coatings with the band-gap determined by using 3.30 eV, 3.33 eV, and 3.33 eV Plot Tuoc. These results indicated that the rate of absorption would be increased by increasing the thickness of film. The increasing thickness of the thin film makes the film hydrophilic able to be used as an anti-fogging substance.
This chapter focuses on the synthesis of silver nanoparticles (AgNPs), AgNP composites, and its role in the structure and electrical properties modification. The research and its various applications of nanoparticles are interesting among others. Silver nanoparticles (AgNPs) are now becoming to take an essential role in the diverse field of application. Establishing the simple and inexpensive of AgNPs is greatly required, since it will also influence it used. Many different methods to obtain AgNPs have been reported. The inducing AgNPs on a various number of other materials has been investigating. We report a brief review of simple AgNP fabrication method at different MSA, PEG, and ultrasonic irradiations regarding its structure and conductivity. We also report the influence of AgNPs on the electrical conductivity of conducting polymers, i.e., PANI, flavonoids of Jatropha multifida L. (JML) and Pterocarpus indicus W. (PIW). It is found that in general, the increase of AgNP concentration gives rise to increase of its electrical conductivity. The conductivity of the AgNPs doped of polymers does not directly reflect by its crystallinity or crystal size. Some exciting aspect of crystal structure and its conductivity are discussed.