Micro Light Emitting Diode (Micro-LED) technology, characterized by exceptional brightness, low power consumption, fast response, and long lifespan, holds significant potential for next-generation displays, yet its commercialization hinges on resolving challenges in high-density interconnect fabrication, particularly micrometer-scale bump formation. Traditional fabrication approaches such as evaporation enable precise bump control but face scalability and cost limitations, while electroplating offers lower costs and higher throughput but suffers from substrate conductivity requirements and uneven current density distributions that compromise bump-height uniformity. Emerging alternatives include electroless plating, which achieves uniform metal deposition on non-conductive substrates through autocatalytic reactions albeit with slower deposition rates; ball mounting and dip soldering, which streamline processes via automated solder jetting or alloy immersion but struggle with bump miniaturization and low yield; and photosensitive conductive polymers that simplify fabrication via photolithography-patterned composites but lack validated long-term stability. Persistent challenges in achieving micrometer-scale uniformity, thermomechanical stability, and environmental compatibility underscore the need for integrated hybrid processes, eco-friendly manufacturing protocols, and novel material innovations to enable ultra-high-resolution and flexible Micro-LED implementations. This review systematically compares conventional and emerging methodologies, identifies critical technological bottlenecks, and proposes strategic guidelines for industrial-scale production of high-density Micro-LED displays.
Transparent conducting gallium-doped ZnO films are deposited on glass substrates by magnetron sputtering of conducting ceramic targets. The dependences of structural, electric, and optical characteristics of ZnO:Ga films on the substrate temperature are investigated during the deposition. Stability of resistivity of films is considered during annealing in air. It is found that the films deposited at the substrate temperature of 250°C have the lowest resistivity of 3.8 × 10−4 Ω cm, while those deposited at 200°C have the highest thermal stability.
Structural, optical, and electric properties of Er2O3 films obtained from Er2O3 ceramic target by the method of vacuum electron-beam deposition on sapphire substrates have been investigated. Optical characteristics of the films are studied in the range from UV up to IR using techniques of absorption, reflection, and emission spectroscopy; specific resistance of the obtained films was also measured. After excitation with the radiation of semiconductor diode laser at 980 nm, IR glow has been obtained at room temperature at the wavelength of approximately 1550 nm from Er3+ ions in polycrystalline ceramic target and in crystalline films. In addition, fluorescence was observed, in the visible range of spectrum, from ceramic target; this fluorescence corresponds to two-step mechanism of excitation with frequency up-conversion.