17 July 2014 in Optics Express
A novel type of few-mode fiber, characterized by an inverse-parabolic graded-index profile, is proposed for the robust transmission of cylindrical vector modes as well as modes carrying quantized orbital angular momentum (OAM). Large effective index separations between vector modes (>2.1 × 10−4) are numerically calculated and experimentally confirmed in this fiber over the whole C-band, enabling transmission of OAM(+/−1,1) modes for distances up to 1.1 km. Simple design rules are provided for the optimization of the fiber parameters.
15 December 2015 in Optics Letters
We propose a polarization-maintaining few-mode fiber (FMF) that features an elliptical ring shaped core with a high refractive index contrast between the core and the cladding. This fiber design alleviates the usual trade-off between the number of guided modes and the achievable birefringence that is usually observed in conventional elliptical-core FMFs. Through numerical simulations, we show that this fiber design can support up to 10 guided vector modes over the entire C band while providing large birefringence. Except for the two fundamental modes, the eight higher-order vector modes are all separated from their adjacent modes by effective index differences , which is the typical birefringence value of single-mode polarization maintaining fibers. The designed fiber targets applications in spatial division multiplexing of optical channels, without multiple-input–multiple-output (MIMO) digital signal processing, for short-reach optical interconnects.
10 May 2017 in Optics Express
We experimentally investigate mode-division multiplexing in an elliptical ring core fiber (ERCF) that supports linearly polarized vector modes (LPV). Characterization show that the ERCF exhibits good polarization maintaining properties over eight LPV modes with effective index difference larger than 1 × 10−4. The ERCF further displays stable mode power and polarization extinction ratio when subjected to external perturbations. Crosstalk between the LPV modes, after propagating through 0.9 km ERCF, is below −14 dB. By using six LPV modes as independent data channels, we achieved the transmission of 32 Gbaud QPSK over 0.9 km ERCF without any multiple-input-multiple-output (MIMO) or polarization-division multiplexing (PDM) signal processing.
27 June 2014 in Optics Letters
We demonstrate a high-power cladding-pumped Er–Yb codoped fiber laser with 74% efficiency. A pump-limited output power of 264 W is obtained using in-band pumping at 1535 nm. We compare the efficiency of 1480 and 1535 nm pumping through numerical simulations and experimental measurements.
14 October 2008 in Journal of Lightwave Technology
We propose and demonstrate experimentally, for the first time, a prototype for all-optical ultra-wideband (UWB) transceiver at 500 Mb/s. We report 1) UWB pulse optimization that takes into account the transmitter RF front end and the U.S. federal communications commission (FCC) spectral mask, 2) a new approximate match filter receiver using optical signal processing, and 3) modulation at 500 Mb/s. Our previous optimization of UWB pulse shapes was based only on the FCC spectral mask, without taking into account the frequency response of the RF components (amplifier and antenna) in the UWB transmitter. Here, we modify our pulse optimization technique to ensure that the equivalent isotropic radiated power (EIRP) from the transmitter meets FCC specifications. For the RF hardware used, we achieve 63.6% efficiency over the FCC mask, which yields an 11.6- and a 5.9-dB improvement over Gaussian monocycle and doublet pulses, respectively. We also introduce simple optical signal processing at the receiver that allows the incoming RF signal to be matched against a square pulse whose duration is adapted to the channel. The exact matched filter would require a new optimized pulse that would include not only hardware frequency response but channel effects that vary with antenna placement as well. The proposed approximation allows a simple variation of the pulse duration: an increase to account for pulse expansion in the channel but an upper limit to combat multipath effects. Finally, we demonstrate the optimized pulse and approximate match filter receiver at 500 M/s. We attain a 10-6bit error rate at a 65-cm separation line of sight (LOS) link with simple on-off keying and no forward error correction.
19 June 2014 in Optics Express
The reflectogram of a fiber grating is used to characterize vector modes of an optical fiber supporting orbital angular momentum states. All modes, with a minimal effective index separation around 10−4, are simultaneously measured. OAM states are reflected by the FBG, along with a charge inversion, at the center wavelength of the Bragg reflection peak of the corresponding fiber vector mode.