Global satellite navigation systems (GNSSs) are the most-used technology for the localization of vehicles in the outdoor environment, but in the case of a densely built-up area or during passage through a tunnel, the satellite signal is not available or has poor quality. Inertial navigation systems (INSs) allow localization dead reckoning, but they have an integration error that grows over time. Inexpensive inertial measurement units (IMUs) are subject to thermal-dependent error and must be calibrated almost continuously. This article proposes a novel method of online (continuous) calibration of inertial sensors with the aid of the data from the GNSS receiver during the vehicle’s route. We performed data fusion using an extended Kalman filter (EKF) and calibrated the input sensors through error backpropagation. The algorithm thus calibrates the INS sensors while the GNSS receiver signal is good, and after a GNSS failure, for example in tunnels, the position is predicted only by low-cost inertial sensors. Such an approach significantly improved the localization precision in comparison with offline calibrated inertial localization with the same sensors.
11 March 2026 in IEEE Transactions on Instrumentation and Measurement
Autonomous vehicles are widely used in many applications in both indoor and outdoor settings. In practical situations with limited GNSS signals or degraded lighting conditions, the navigation solution may rely only on inertial sensors and as result drift in time due to errors in the inertial measurement. In this work, we propose WiCHINS, a wheeled and chassis inertial navigation system by combining wheel-mounted-inertial sensors with a chassis-mounted inertial sensor for accurate pure inertial navigation. To that end, we derive a three-stage framework, each with a dedicated extended Kalman filter. This framework utilizes the benefits of each location (wheel/body) during the estimation process. To evaluate our proposed approach, we employed a dataset with five inertial measurement units with a total recording time of 228.6 minutes. We compare our approach with four other inertial baselines and demonstrate an average position error of 11.4 m, which is 2.4% of the average traveled distance, using two wheels and one body inertial measurement units. As a consequence, our proposed method enables robust navigation in challenging environments and helps bridge the pure-inertial performance gap.
Autonomous vehicles and wheeled robots are widely used in many applications in both indoor and outdoor settings. In practical situations with limited GNSS signals or degraded lighting conditions, the navigation solution may rely only on inertial sensors and as result drift in time due to errors in the inertial measurement. In this work, we propose WiCHINS, a wheeled and chassis inertial navigation system by combining wheel-mounted-inertial sensors with a chassis-mounted inertial sensor for accurate pure inertial navigation. To that end, we derive a three-stage framework, each with a dedicated extended Kalman filter. This framework utilizes the benefits of each location (wheel/body) during the estimation process. To evaluate our proposed approach, we employed a dataset with five inertial measurement units with a total recording time of 228.6 minutes. We compare our approach with four other inertial baselines and demonstrate an average position error of 11.4m, which is $2.4\%$ of the average traveled distance, using two wheels and one body inertial measurement units. As a consequence, our proposed method enables robust navigation in challenging environments and helps bridge the pure-inertial performance gap.