In this paper, we present a multiphysics modeling of rare earth–doped cladding–pumped fiber amplifiers to predict the device performance with respect to the constraints associated with space missions. By combining the 3-D non-homogeneous heat conduction equation with the nonlinear rate equations, the developed numerical algorithm makes possible the calculation of the spatial distribution of the different optical signals and temperature profiles. The temperature dependence of the refractive index, emission and absorption cross sections, as well as the radiation induced attenuation and the lifetime versus the deposited dose have been considered, too. They lead to the change of the optical signals inside the fiber creating a feedback loop that influences the temperature distribution within the fiber. Different operational regimes for a representative fiber design as well as different cooling configurations have been investigated. According to the study carried out by using the developed multiphysics modeling it can be inferred that the thermal field inside the fiber could strongly deteriorate the amplifier performance especially in the space radiation environment.
6 November 2013 in IEEE Photonics Technology Letters
In this letter, we investigate the impact of a 405 nm radiation on photodarkening generation in Yb-doped fiber laser. Simultaneous photodarkening and photobleaching effects induced by 976 and 405 nm radiations, respectively, were investigated in a 1070 nm laser and compared with the loss induced in an irradiated active fiber. We observed a significant photobleaching effect due to 405 nm radiation but not a complete recovery. A strong absorption of the 405 nm radiation by the excited ions was also observed and could be the limiting factor for the bleaching performance. We also observed for the first time, to the best of our knowledge, ground-state absorption induced photodarkening in pristine fiber irradiated at 405 nm. This effect could generate additional residual losses in the laser system.
We report the experimental performance of a packaged dual-stage all-single-clad broadband polarization maintaining (PM) Tm-doped silica fiber amplifier (TDFA) with a high signal output power of 2.2 W at 1909 and 1951 nm. Our novel design incorporates an uncooled 940 nm multimode semiconductor pump laser source. Combined high gain of > 46 dB, wide operating bandwidth of 1875—2000 nm, low noise figure of 7 dB, high OSNR of >54 dB/0.1 nm, and a PER of > 20 dB are achieved with our TDFA.
28 October 2020 in Journal of Lightwave Technology
We report the design and performance of a packaged broadband PM hybrid HDFA/TDFA in the 2000—2100 nm band using all-single-clad doped fibers. Internal small signal G = 49.1 dB, small signal NF = 6.5 dB, and Pout = 3.54 W are achieved at ${\lambda_{s}}$ = 2051 nm. The simulated 3 dB output power bandwidth is 98 nm. Comparisons of experimental data and simulations show good agreement. We investigate through simulations an all-Holmium two stage PM optical amplifier design for comparison to the hybrid PM HDFA/TDFA.
thirteen different single-mode optical fibers have been experimentally and theoretically characterized highlighting the influence of the core and cladding dopants on their Brillouin signatures: Brillouin spectrum, temperature and strain coefficients. Tailoring the composition and the refractive index profile, optical fibers presenting Brillouin spectrum with multiple peaks have been designed, offering discrimination capabilities between the temperature and strain distributions along a single optical fiber.
In this publication we show how it is possible to eliminate photodarkening in ytterbium-doped double-clad fibers using the modified chemical vapor deposition technique; this is done through the systematic and thorough optimization of the process parameters and of the host matrix.