Qinghai Engineering Research Center for Gold Mineral Resource Development Dressing and Metallurgy Pilot Plant, Dulan Jin Hui Mining Limited Corporation, Haixi Zhou 816100, China
Auto-generated profile, based on publicly available information
Youguo Guan
Qinghai Engineering Research Center for Gold Mineral Resource Development Dressing and Metallurgy Pilot Plant, Dulan Jin Hui Mining Limited Corporation, Haixi Zhou 816100, China
Effective flotation of fine particles is a problem for mineral processing. In this paper, a flocculant mostly used in heavy metal ion treatment was used in an arsenopyrite flotation system. The adsorption behavior and flotation performance of PEI on the xanthate flotation of arsenopyrite were investigated through zeta potential and adsorbed amount measurements, XPS and size distribution detections, and micro-flotation tests. Zeta potential results showed that the adsorption of 40 mg/L polyethyleneimine (PEI) caused an increase in the zeta potential of arsenopyrite, and had only a slight depression on the further adsorption of SBX, which was further confirmed by the results of the adsorbed amount measurements. However, when the dosage of PEI was 150 mg/L, the adsorption of SBX was strongly depressed. This was because moderate PEI only bridged different arsenopyrite particles, and most of the active sites for the SBX adsorption were still exposed; when PEI was in excess, the mineral particles would be covered so that there were not enough active sites for SBX adsorption. Fe and As on the mineral surface were the adsorption sites for the PEI molecules, which were resolved from the chemical shifts in the As/Fe peaks of the XPS spectra. PEI can increase particle size, and moderate PEI dosage can make the particle size suitable for flotation with SBX where bridging and hydrophobic effects take place. The flotation results showed that −20 μm arsenopyrite particles had poor flotation recovery with the SBX collector alone, but when they were treated with 40 mg/L PEI, the recovery largely increased. PEI can serve as an effective flocculant for the flocculation flotation of fine arsenopyrite. A comparison model, showing the possible interactions among reagents, particles, and bubbles in the pulp with different PEI dosages, is proposed.
The effects of ZnSO4 on arsenopyrite depression were studied with sodium carbonate and sodium isobutyl xanthate (SIBX) as the pH regulator and collector, respectively. In both micro and real ore flotation tests, ZnSO4 showed better depression on arsenopyrite (pH 7.5–9.0 adjusted by Na2CO3) compared with sodium humate. The depression mechanism of ZnSO4 on arsenopyrite flotation was studied by electrokinetic potential, adsorbed amount measurements, scanning electron microscope (SEM) observation and energy dispersive spectra (EDS) detection. The electrokinetic potential measurement results show a potential increase forpleas the arsenopyrite treated with ZnSO4 in the pH range 7.5–9.0, which could be attributed to the formation of the precipitated zinc carbonate (ZnCO3(S)). For arsenopyrite treated with both ZnSO4 and SIBX, the electric surface potentials also display an increase, to approximate the values with solely ZnSO4 treated, at pH 7.5–9.0, indicating the inhibition of ZnCO3(S) upon the SIBX adsorption onto arsenopyrite. Adsorption results demonstrated that SIBX adsorption onto arsenopyrite indeed was inhibited at the pH 7.5-9.0 through the sharp decrease in SIBX adsorbed amount with ZnSO4 as the depressant at this pH range. SEM observation and EDS detection results verify the formation of colloidal ZnCO3 on the arsenopyrite, with ZnSO4 as the depressant in combination with Na2CO3.