1 August 2014 in Construction and Building Materials
1 October 2017 in IOP Conference Series: Materials Science and Engineering
1 March 2013 in Construction and Building Materials
15 October 2017 in Open Engineering
The reinforcing effect of fibers in cement composites often results in the improvement of the brittle nature of cementitious materials. But the decrease in the workability of fresh concrete is often the disadvantage of fibers addition. Conventional single-point workability tests cannot characterize workability of concrete in terms of fundamental rheological parameters. To this end, this paper describes an investigation of the influence of synthetic fiber additions (fiber length in the range 12–50 mm and volume fraction in the range 0–4%) on the rheological properties of fiber reinforced fresh mortar (FRFM) and development of these properties over time. The rheometer Viskomat XL was used in this study. Within the limitations of the instrument and testing procedure it is shown that FRFMs conform to the Bingham model. Natural postglacial sand 0/4 mm was used as a fine aggregate and cement CEMI 42.5 R was used as a binder. Three commercial synthetic fibers were selected for these examinations. Rheological properties were expressed in terms of Bingham model parameters g (yield value ) and h (plastic viscosity). Based on the test results it was found out that the fiber type and volume fraction affected both the yield stress and plastic viscosity.
4 November 2017 in Open Engineering
The quality of the autoclaved aerated concrete (AAC) strongly depends on the chemical composition of the raw materials, as well as on the process of the hydrothermal reaction during autoclaving. Performance parameters depend on material structure: fine micron-scale matrix porosity generated by the packing of thin tobermorite plates and coarse aeration pores arising from the foaming of wet mix. In this study the binder varied in calcium sulfate dihydrate (CaSO4⋅2H2O) content. Five series of AAC specimens were produced, with gypsum content 0; 0.55; 1.15; 2.3 and 3.5% of dry mass respectively. AAC units were produced in UNIPOL technology. The study presents experimental results of AAC moisture stabilization. The initial moisture content was determined directly after autoclaving. Slower drying process was observed for samples containing over 2% of gypsum. Whereas other performance parameters, compressive and tensile strength, as well as water absorption and capillary rise, were significantly better comparing to the reference AAC samples.
26 June 2018 in MATEC Web of Conferences
The possibility of recycling waste from medium density fiberboard (MDF) production into wood-cement composites was evaluated. A large quantity of lignocellulosic wastes is generated worldwide from various sources, including wood and furniture industries, leading to environmental concerns. Medium density fiberboard (MDF) is an engineered wood product, which is made from wood fibers (mainly form coniferous trees) with wax and a resin binder. This paper presents an experimental study which investigated the potential utilization of medium density fiberboard wastes (MDFW) for producing lightweight insulation concrete. The wastes were screened on #8 mm sieve to exlude big irregular elements which could negatively affect compaction and strength properties. All lignocellulosic substrates have detrimental effects on cement setting so different techniques were applied to offset the retarding effect of compounds like sugar and tannin present in the bio-based particles before mixing the wastes with cement. One type of cement CEM I 42,5 R was used in the experiment. Flexural strength, compressive strength in air-dry and wet states, and water absorption of lightweight concrete were tested. Compressive strength ranging from 0,5 to 5.3 MPa was obtained depending on the material used for the initial impregnation of MDFW fibers.