3 February 2017 in Optics Express
In this paper, we demonstrate 67 fs pulse emitting with tungsten disulfide (WS2) in mode-locked erbium-doped fiber (EDF) lasers. Using the pulsed laser deposition method, WS2 is deposited on the surface of the tapered fiber to form the evanescent field. The fiber-taper WS2 saturable absorber (SA) with the large modulation depth is fabricated to support the ultrashort pulse generation. The influences of the WS2 SA are analyzed through contrastive experiments on fiber lasers with or without the WS2 SA. The pulse duration is measured to be 67 fs, which is the shortest pulse duration obtained in the mode-locked fiber lasers with two dimensional (2D) material SAs. Compared to graphene, topological insulator, and other transition metal dichalcogenides (TMDs) SAs, results in this paper indicate that the fiber-taper WS2 SA with large modulation depth is a more promising photonic device in mode-locked fiber lasers with the wide spectrum and ultrashort pulse duration.
3 March 2017 in Nanoscale
Tungsten disulphide (WS2), which exhibits excellent saturable absorption properties, has attracted much attention in the applications of photonic devices. In this paper, WS2 is applied for the preparation of a saturable absorber (SA). Using the pulsed laser deposition (PLD) method, WS2 is deposited on the side surface of the tapered fiber. In order to obtain larger non-linearity of the SAs with evanescent wave interaction, the tapered fiber had a smaller waist diameter and longer fused zone. Gold film was deposited on the fiber-taper WS2 SAs to improve their reliability and avoid oxidation and corrosion. Employing the balanced twin-detector method, the modulation depth of the fiber-taper WS2 SAs was measured to be 17.2%. With the fiber-taper WS2 SA, a generated pulse with 246 fs duration and a 57 nm bandwidth was obtained at 1561 nm. The electrical signal to noise ratio was better than 92 dB. To our knowledge, the pulse duration was the shortest among the reported all-fiber lasers with transition metal dichalcogenide (TMD) SAs. These results indicate that fiber-taper WS2 SAs with smaller waist diameter and longer fused zone are promising photonic devices for ultrashort pulse generation in all-fiber lasers.
28 February 2018 in Photonics Research
Two-dimensional (2D) materials with potential applications in photonic and optoelectronic devices have attracted increasing attention due to their unique structures and captivating properties. However, generation of stable high-energy ultrashort pulses requires further boosting of these materials’ optical properties, such as higher damage threshold and larger modulation depth. Here we investigate a new type of heterostructure material with uniformity by employing the magnetron sputtering technique. Heterostructure materials are synthesized with van der Waals heterostructures consisting of and . The bandgap, carrier mobility, and carrier concentration of the heterostructure materials are calculated theoretically. By using these materials as saturable absorbers (SAs), applications in fiber lasers with -switching and mode-locking states are demonstrated experimentally. The modulation depth and damage threshold of SAs are measured to be 64.17% and , respectively. Both theoretical and experimental results indicate that heterostructure materials have large modulation depth, and can resist high power during the generation of ultrashort pulses. The heterostructure materials have the advantages of low cost, high reliability, and suitability for mass production, and provide a promising solution for the development of 2D-material-based devices with desirable electronic and optoelectronic properties.
27 April 2016 in Photonics Research
Tungsten disulfide () is a type of anisotropic-layered compound and has broadband saturable absorption features as saturable absorbers (SAs). With -based SAs, dark solitons in erbium-doped fiber (EDF) lasers are first obtained. For the generated dark solitons, the center wavelength is measured to be 1530 nm, and the repetition rate is about 116.5 MHz. A series of optical spectra is exhibited. The electrical signal-to-noise ratio is better than 94 dB. Results in this paper demonstrate that -based SAs are the promising SAs for generating dark solitons in EDF lasers.
24 January 2017 in Optics Letters
Supercontinuum generation in a solid-state medium was investigated experimentally. A continuum covering 460 to 950 nm was obtained when 0.8 mJ/30 fs Ti:sapphire laser pulses were applied to seven thin fused silica plates at a 1 kHz repetition rate. The primary processes responsible for spectral broadening were self-phase modulation (SPM) and self-steepening, while SPM and self-focusing were balanced to optimize the spectral broadening and suppress the multiphoton process. The output was compressed to a 5.4 fs and a 0.68 mJ pulse, corresponding to two optical cycles and 0.13 TW of peak power.