School of Metallurgical Engineering and Materials Science, Faculty of Engineering, Universidad Central de Venezuela, Postal Address 47885, Los Chaguaramos, Caracas 1041, Venezuela
Auto-generated profile, based on publicly available information
Jose Gregorio La Barbera Sosa
School of Metallurgical Engineering and Materials Science, Faculty of Engineering, Universidad Central de Venezuela, Postal Address 47885, Los Chaguaramos, Caracas 1041, Venezuela
The present investigation has been conducted in order to determine the microstructural features, hardness and elastic modulus of two different WC–Co and WC–Co–Cr high velocity oxy fuel sprayed coatings. Particular emphasis has been given to the evaluation of the elastic modulus on the surface and cross-section of both coatings, employing three different indenters and the influence of the applied load on such property. For this purpose, both conventional and instrumented indentation tests were carried out on the surface and cross-section of the coatings. The elastic modulus was computed by means of the Oliver and Pharr method (1992; 2004) and compared with the values determined by means of the Marshall et al. method (1982). The values of the elastic modulus found both on the surface and on the cross-section of the samples were ∼250 GPa, which indicates a quasi-isotropic behaviour due to the uniform and dense microstructure observed along both directions.
1 December 2006 in International Journal of Fatigue