The basic P&O technique fails to track the MPP when a rapid change in luminosity and/or temperature has occurred because it cannot distinguish between disturbance of PV voltage and rapid change in environmental conditions. This study presents drawbacks of the basic algorithm and proposes a new variant of P&O with three incremental steps to differentiate the two states mentioned above, thus avoiding divergences in the MPPT path. The suggested MPPT command consists of a modified P&O algorithm applied to a boost converter to overcome poor transient responses and thus optimize the efficiency of the entire PV system. The proposed tracker is built using a 60 W module and its performance is verified by simulations with MATLAB tools considering quick change in the solar irradiance, temperature and load. The test results demonstrate the feasibility and improved performance of the system. The modified P&O technique effectively tracks the MPP in various work situations and capable of increasing energy transfer efficiency by nearly 5%.
1 January 2024 in International Journal of Smart grid
Knowing that a large number of MPPT (maximum power point tracking) techniques exist so far and that each technique has its own advantages and disadvantages. Therefore, an appropriate examination of these techniques is indispensable to facilitate the selection of one of the more appropriate ones for a given application. This document provides a summary of these MPPT algorithms. Among them, four commonly used are examined and compared using five evaluation criteria. Perturb and observe (PO), incremental conductance (IC), sliding mode (SM), and fuzzy logic (FL) control are selected for this study and tested under a rapid change of illumination. A combined step and ramp changes in solar illumination is used to assess the effectiveness of the chosen MPPTs. The simulations of the PV system are performed by Simulink tools of MATLAB software. The results conclude that the fuzzy logic controller is the best MPP (maximum power point) tracker due to the absence of steady-state oscillations and its average efficiency of 98%. Second place belongs to the slide mode control which is the fastest and has small fluctuations. In addition, the best MPPT is successfully tested for a change in temperature and load.
1 January 2024 in International Journal of Smart grid
This paper presents a hybrid electric vehicle charging station powered by both a PV source and the utility grid, incorporating an energy management strategy that prioritizes the utilization of solar energy while exporting surplus power to the grid during periods of low charging demand. To enhance the performance of maximum power point tracking, a hybrid control strategy integrating the grey wolf optimizer (GWO) and the super-twisting algorithm (STA) is proposed. The GWO performs rapid global exploration to accurately identify the maximum power point, whereas the STA ensures precise, robust, and chattering-free tracking under steady-state operating conditions. The proposed system was modeled in MATLAB/Simulink and validated under a dynamic irradiance profile characterized by both abrupt and gradual variations. Simulation results demonstrate a convergence time of 2-3 ms, residual power oscillations below 0.1%, and an average tracking efficiency of 99.38%. Compared with conventional MPPT techniques, the proposed STA-GWO approach significantly suppresses steady-state oscillations, accelerates convergence, and prevents MPP tracking failure under rapid irradiance fluctuations through the global optimization capability of GWO. These findings highlight the effectiveness of the proposed hybrid MPPT strategy in improving the robustness, energy conversion efficiency, and grid integration capability of PV-powered EV charging stations, making it a promising solution for next-generation sustainable charging infrastructure.