28 November 2024 in Advanced Optical Materials
Chalcogenide optical phase change materials (PCMs) have garnered significant interest for their growing applications in programmable photonics, optical analog computing, active metasurfaces, and beyond. Limited endurance or cycling lifetime is however increasingly becoming a bottleneck toward their practical deployment for these applications. To address this issue, a systematic study elucidating the cycling failure mechanisms of Ge 2 Sb 2 Se 4 Te (GSST) is performed, a common optical PCM tailored for infrared photonic applications, in an electrothermal switching configuration commensurate with their applications in on‐chip photonic devices. Further a set of design rules building on insights into the failure mechanisms is proposed, and successfully implemented them to boost the endurance of the Ge 2 Sb 2 Se 4 Te (GSST) device to over 67 000 cycles.
6 September 2023 in Optical Materials Express
Bragg gratings offer high-performance filtering and routing of light on-chip through a periodic modulation of a waveguide’s effective refractive index. Here, we model and experimentally demonstrate the use of Sb2Se3, a nonvolatile and transparent phase-change material, to tune the resonance conditions in two devices which leverage periodic Bragg gratings—a stopband filter and Fabry-Perot cavity. Through simulations, we show that similar refractive indices between silicon and amorphous Sb2Se3 can be used to induce broadband transparency, while the crystalline state can enhance the index contrast in these Bragg devices. Our experimental results show the promise and limitations of this design approach and highlight specific fabrication challenges which need to be addressed in future implementations.
11 November 2024 in Optical Materials Express
Phase change materials (PCMs) are important building blocks in solid-state memory and photonic devices. Solution-based processing promises large-area, cost-effective, conformal coating of optical PCMs (O-PCMs) for photonic applications. In this work, a solution processing route was developed for Ge2Sb2Se4Te1 (GSST), a target PCM of interest due to its large optical contrast, broadband transparency, and improved glass-forming capability. An alkahest solvent mixture of ethanedithiol and ethylenediamine was used as a solvent system to fabricate solution-derived GSST thin films and films from these solutions were prepared and characterized using SEM, XRD, and Raman spectroscopy.
8 May 2026 in Optics Letters
Electrically reconfigurable photonics based on optical phase change materials (PCMs) has attracted surging interest recently, with broad potential applications ranging from analog computing to optical camouflage. PCM switching in these devices is customarily implemented using resistive micro-heaters. These electrically conductive micro-heaters, however, cause significant optical losses due to free carrier absorption. In this paper, we present a design concept that overcomes this limitation without compromising the electrical performance of the micro-heaters. Using doped Si heaters as an example, we show that such parasitic losses can be suppressed by engineering the optical mode to minimize the optical field overlap with the lossy doped region. An active optical meta-grating design was proposed based on the concept, which achieves 2 π phase tuning range near 1.53 μm wavelength with only 10 nm thick Sb 2 S 3 while maintaining over 85% optical efficiency.