28 November 2022 in Applied Physics Letters
Vertical metal–oxide–semiconductor field effect transistor (MOSFET) is essential to the future application of ultrawide bandgap β-Ga2O3. In this work, we demonstrated an enhancement-mode β-Ga2O3 U-shaped gate trench vertical metal–oxide–semiconductor field effect transistor (UMOSFET) featuring a current blocking layer (CBL). The CBL was realized by high-temperature annealing under oxygen ambient, which provided electrical isolation between the source and drain electrodes. The CBL thicknesses of different annealing temperatures were derived from C–V measurements and the Fermi level position of the sample surfaces of different annealing temperature was characterized by x-ray photoelectron spectroscopy measurements, indicating good process controllability. Furthermore, photoluminescence spectra were measured to study the effect of oxygen annealing. The fabricated UMOSFET showed normally off with a Vth of 11.5 V, an on-state resistance of 1.48 Ω cm2, a maximum on-state current of 11 A/cm2, an on–off ratio of 6 × 104, and a three-terminal breakdown voltage over 100 V. This work paves a way to form a CBL and broadens the design space for high-power β-Ga2O3 vertical transistors.
15 August 2023 in IEEE Electron Device Letters
In this study, we fabricated superb β-Ga 2 O 3 Schottky barrier diodes (SBDs) with high breakdown voltage ( V br ) and low leakage through combining platinum oxide (PtO x ) and anodic self-aligned mesa termination (SAMT). The PtO x that forms a high barrier with β-Ga 2 O 3 enables the SAMT to function sufficiently. The in-situ annealing dry etch process repair the mesa sidewall and improve the Schottky contact well. SBDs with different mesa-etched depths ( D ee ) were systematically studied, including 0, 0.3, 0.6, 0.9, and 1.2 μm. The results showed that the V br of the PtO x /β-Ga 2 O 3 SBD increased from 1120 V to 2738 V, yielding a high power figure of merit (PFOM) of 1.02 GW/cm 2 . Meanwhile, the device maintained a less than 10 μA/cm 2 leakage current density until -2000 V. Devices with radii of 200, 100, and 50 μm obtained highest V br of 2508, 2772, and 2738 V at a D ee of 1.2 μm, respectively. The devices can be passivated by SU-8 without V br degradation. This work provides an effective method for further improving the performance of β-Ga 2 O 3 SBDs and promotes the application of β-Ga 2 O 3 power diodes.
8 February 2023 in IEEE Transactions on Electron Devices
In this work, we demonstrate a novel conductivity-controlled junction termination extension (JTE) technique using p-type NiO—a key element for the potential commercialization of Ga2O3 power devices. The surface electric field at the Schottky edge is effectively suppressed by the p-type NiO JTE. Simultaneously, it can control the concentration of p-type NiO to maximize the breakdown voltage ( ${V}_{\text {br}}$ ) by changing the gas atmosphere during magnetron sputtering growth. The electrical characteristics of the $\beta $ -Ga2O3 Schottky barrier diodes (SBDs) with p-type NiO JTE are studied systematically. All $\beta $ -Ga2O3 SBDs with JTE show great advantages in terms of device performance parameters whether at room temperature or high temperature, which indicates the effectiveness of p-NiO JTE in reducing the fringe electric field. In particular, the $\beta $ -Ga2O3 SBDs with an optimized hole concentration of approximately $10^{{17}}$ cm $^{-{3}}$ for NiO in the JTE region exhibit a low specific ON-resistance of 2.9 $\text{m}\Omega $ cm2 and a high ${V}_{\text {br}}$ of 2.11 kV, yielding a high power figure-of-merit (PFOM) of 1.54 GW/cm2. Our results demonstrate the great potential of p-NiO as a controllable and reliable technique for junction engineering in $\beta $ -Ga2O3 power devices.
10 January 2023 in IEEE Electron Device Letters
High-performance $\beta $ -Ga2O3 U-shaped trench-gate metal-oxide-semiconductor field-effect transistor (UMOSFET) has been demonstrated. Nitrogen ions implantation was employed to form current blocking layer. Electrons in the blocking layer can accumulate in the area near the U-shaped groove and form a conductive channel to promote current generation at a positive gate bias. The UMOSFET with an applicable threshold voltage of 4.2 V was achieved by modulating the concentration of implanted nitrogen ions. A high current density of 702.3 A/cm2, a low on-resistance of 10.4 $\text{m}\Omega \cdot $ cm2, and a decent breakdown voltage of 455 V (at ${V}_{\text {G}}=0$ V) were obtained for UMOSFET with N ions concentration of ${5}\times {10} ^{{18}}$ cm $^{-{3}}$ . The UMOSFET in this work offers exceptional advantages in fabrication of high-performance E-mode vertical $\beta $ -Ga2O3 MOSFETs, facilitating the development of $\beta $ -Ga2O3 power electronics devices.
8 September 2022 in IEEE Electron Device Letters
Selective area doping technique is essential for diversifying semiconductor device structures. In this letter, selective high-resistance zones on β-Ga 2 O 3 wafers were successfully achieved by a high-temperature oxygen annealing process. Polysilicon, which proved to have an ideal blocking capability against oxygen annealing ambient, was employed as an annealing cap layer to prevent local carrier concentration changes during annealing. Based on this unique process approach, we further demonstrate a high-resistance anode edge termination of Schottky barrier diodes, which can considerably reduce the leakage current and increase the breakdown voltage of the devices. This research broadens the device manufacturing method and promotes the development of Ga 2 O 3 devices.
9 February 2023 in IEEE Transactions on Electron Devices
Superior performance $\beta $ -gallium oxide ( $\beta $ -Ga2O3) junction barrier Schottky (JBS) diode with a forward conduction current of 5.1 A (@2 V) and reverse breakdown voltage of 1060 V with an area of ${3} \times {3}$ mm2 is presented. Meanwhile, the high power figure of merit (PFOM) of 0.72 GW/cm2 is attributed to the implementation of the pn heterojunction and beveled field plate for a ${0}.{1} \times {0}.{1}$ mm2 diode. The switching characteristics of large-size $\beta $ -Ga2O3 JBS after encapsulation reveal a short reverse recovery time of 26.8 ns under switching conditions of di / dt up to 400 A/ $\mu \text{s}$ . In addition, a hybrid half-wave (HW) Cockcroft–Walton (CW) voltage multiplier is built first together with commercial SiC SBD, and the results show the competitive characteristics of $\beta $ -Ga2O3 JBS for SiC SBD, such as the almost same multiplication factor up to 3.81 in four-stage hybrid voltage multipliers compared with an all-SiC SBD-based circuit. The circuit efficiency is approximately 86.07% for $\beta $ -Ga2O3 diode-based hybrid voltage multipliers. These results demonstrate the enormous application potential of $\beta $ -Ga2O3 JBS significantly.