1 July 2009 in Journal of Guidance, Control, and Dynamics
This paper presents a new method for estimating the parameters of multichannel pilot models that is based on maximum likelihood estimation. To cope with the inherent nonlinearity of this optimization problem, the gradientbased Gauss–Newton algorithm commonly used to optimize the likelihood function in terms of output error is complemented with a genetic algorithm. This significantly increases the probability of finding the global optimum of the optimization problem. The genetic maximum likelihood method is successfully applied to data from a recent human-in-the-loop experiment. Accurate estimates of the pilot model parameters and the remnant characteristics are obtained. Multiple simulations with increasing levels of pilot remnant are performed, using the set of parameters found from the experimental data, to investigate how the accuracy of the parameter estimate is affected by increasing remnant. It is shown that the bias in the parameter estimates is only substantial for very high levels of pilot remnant. Some adjustments to the maximum likelihood method are proposed to reduce this bias
27 October 2017 in IEEE Transactions on Human-Machine Systems
Manual control cybernetics aims to understand and describe how humans control vehicles and devices using mathematical models of human control dynamics. This “cybernetic approach” enables objective and quantitative comparisons of human behavior, and allows a systematic optimization of human control interfaces and training associated with manual control. Current cybernetics theory is primarily based on technology and analysis methods formalized in the 1960s and has shown to be limited in its capability to capture the full breadth of human cognition and control. This paper reviews the current state-of-the-art in our knowledge of human manual control, points out the main fundamental limitations in cybernetics, and proposes a possible roadmap to advance the theory and its applications. Central in this roadmap will be a shift from the current linear time-invariant modeling approach that is only truly valid for human behavior under tightly controlled and stationary conditions, to methods that facilitate the analysis of adaptive, and possibly time-varying, human behavior in realistic control tasks. Examples of key current developments in the field of cybernetics—human use of preview, predictable discrete maneuvering, skill acquisition and training, time-varying human modeling, and neuromuscular system modeling—that contribute to this shift are presented in this paper. The new foundations for cybernetics that will emerge from these efforts will impact all domains that involve humans in manual and semiautomatic control.
1 March 2009 in Journal of Guidance, Control, and Dynamics
1 February 2013 in IEEE Transactions on Cybernetics
In the manual control of a dynamic system, the human controller (HC) often follows a visible and predictable reference path. Compared with a purely feedback control strategy, performance can be improved by making use of this knowledge of the reference. The operator could effectively introduce feedforward control in conjunction with a feedback path to compensate for errors, as hypothesized in literature. However, feedforward behavior has never been identified from experimental data, nor have the hypothesized models been validated. This paper investigates human control behavior in pursuit tracking of a predictable reference signal while being perturbed by a quasi-random multisine disturbance signal. An experiment was done in which the relative strength of the target and disturbance signals were systematically varied. The anticipated changes in control behavior were studied by means of an ARX model analysis and by fitting three parametric HC models: two different feedback models and a combined feedforward and feedback model. The ARX analysis shows that the experiment participants employed control action on both the error and the target signal. The control action on the target was similar to the inverse of the system dynamics. Model fits show that this behavior can be modeled best by the combined feedforward and feedback model.
7 January 2019 in IEEE/ASME Transactions on Mechatronics
High precision motion control of hydraulic manipulators is challenging due to the highly nonlinear dynamics and model uncertainties typical for hydraulic actuators. This paper addresses the implementation of a novel sensor-based Incremental Nonlinear Dynamic Inversion control technique for a high-precision hydraulic force controller in existence of parameter uncertainties. Combined with a widely used force computation outer-loop controller, the proposed motion control structure is implemented on a 6-DOF hexapod hydraulic robot, the SIMONA (Simulation, Motion and Navigation) Research Simulator at TU Delft. The proposed control technique is inherently robust to hydraulic parameter uncertainties. As an important contribution, the robustness against parameter uncertainty is rigorously proven. Stability of the proposed controller is also analysed. Techniques for solving characteristic implementation issues, such as higher-order valve dynamics and oil transmission effects, are discussed in detail. Motion tracking experiment results on the SIMONA simulator validate the effectiveness of the proposed method in terms of performance and the robustness against parameter uncertainties. Significant control accuracy improvement is demonstrated by comparing with the state-of-the-art motion control implementations.
1 November 2008 in Journal of Guidance, Control, and Dynamics
In this paper, the effects of peripheral visual and physical motion cues on manual control of second-order roll dynamics are investigated. In particular, the differences between the use of these cues in compensatory targetfollowing and disturbance-rejection tasks are considered. Tracking performance, control activity, and measures of control behavior are determined from recent measurements and compared with results from an earlier experiment. Most previously reported effects of peripheral visual and physical motion cues in target following and disturbance rejection are confirmed. A comparison of tasks with varying levels of difficulty is found to reveal reduced effectiveness of peripheral visual and physical motion cues in the less difficult target-following tasks only. Observed differences in measured control behavior for target following and disturbance rejection are related to effective strategies for reducing tracking errors introduced by the forcing-function signals in both tasks