8 October 2018 in Applied Physics Letters
In this letter, gate leakage mechanisms in different gate contact normally off p-GaN/AlGaN/GaN high electron mobility transistors (HEMTs) have been studied by the temperature-dependent current-voltage (IG-VG) measurement. It is found that two-dimensional variable range hopping is responsible for gate leakage current at the reverse gate bias and low forward gate bias in both high-leakage and low-leakage Schottky gate contact devices. At high forward gate bias, in the case of high-leakage Schottky contact, the dominant current conduction mechanism is found to be thermionic field emission while it is Poole–Frenkle emission (PFE) for the case of low-leakage Schottky contact and the activation energy of trap states for PFE current is derived as 0.6 eV. Besides, related models are also proposed to describe the gate leakage current in p-GaN gate HEMTs and they match well with the experimental gate leakage current within a wide range of temperatures and gate biases.
10 October 2016 in Applied Physics Letters
In this letter, we report a method by introducing hydrogen plasma treatment to realize normally-off p-GaN/AlGaN/GaN HEMT devices. Instead of using etching technology, hydrogen plasma was adopted to compensate holes in the p-GaN above the two dimensional electron gas (2DEG) channel to release electrons in the 2DEG channel and form high-resistivity area to reduce leakage current and increase gate control capability. The fabricated p-GaN/AlGaN/GaN HEMT exhibits normally-off operation with a threshold voltage of 1.75 V, a subthreshold swing of 90 mV/dec, a maximum transconductance of 73.1 mS/mm, an ON/OFF ratio of 1 × 107, a breakdown voltage of 393 V, and a maximum drain current density of 188 mA/mm at a gate bias of 6 V. The comparison of the two processes of hydrogen plasma treatment and p-GaN etching has also been made in this work.
1 March 2018 in AIP Advances
In this paper, we have studied the performance of Ti/Al/Ni/Au ohmic contact with different Al and Au thicknesses and pretreatments. The temperature dependence of contact resistances (Rc) was investigated and it shows that there are different optimal annealing temperatures with different metal thicknesses and pretreatments. The optimal annealing temperature is affected by Al and Au thickness and AlGaN thickness. The etched AlGaN barrier is useful to achieve good ohmic contact (0.24 Ω·mm) with a low annealing temperature. Only the contact resistances of the samples with 130 nm Al layer kept stable and the contact resistances of the samples with 100nm and 160 nm Al layers increased with the measurement temperatures. The contact resistances showed a similar increase and then keep stable trend for all the samples in the long-term 400 °C aging process. The ohmic metal of 20/130/50/50 nm Ti/Al/Ni/Au with ICP etching is the superior candidate considering the contact resistance and reliability.
9 September 2019 in Applied Physics Letters
In this letter, E-mode n-GaN gate heterostructure field effect transistors (HFETs) utilizing polarization induced 2D hole gas (2DHG) have been proposed. It is found that the introduction of the n-GaN cap between the GaN channel layer and the gate metal can effectively deplete the 2DHG in the gate region, resulting in E-mode operation. The simulation results indicate that by adjusting the GaN channel thickness and n-GaN cap doping concentration, threshold voltage of the n-GaN gate p-channel HFETs can be more than |−1.5| V without sacrificing the ON-state current and the ON/OFF ratio, which is enabled to overcome the trade-off observed from conventional p-channel devices.
1 December 2017 in AIP Advances
In this letter, high-resistivity unintentionally carbon-doped GaN layers with sheet resistivity greater than 106 Ω/□ have been grown on c-plane sapphire substrates by metal-organic chemical vapor deposition (MOCVD). We have observed that the growth of GaN nucleation layers (NLs) under N2 ambient leads to a large full width at half maximum (FWHM) of (102) X-ray diffraction (XRD) line in the rocking curve about 1576 arc sec. Unintentional carbon incorporation can be observed in the secondary ion mass spectroscopy (SIMS) measurements. The results demonstrate the self-compensation mechanism is attributed to the increased density of edge-type threading dislocations and carbon impurities. The AlGaN/GaN HEMT grown on the high-resistivity GaN template has also been fabricated, exhibiting a maximum drain current of 478 mA/mm, a peak transconductance of 60.0 mS/mm, an ON/OFF ratio of 0.96×108 and a breakdown voltage of 621 V.
1 December 2017 in AIP Advances
In this letter, we have studied the performance of AlGaN/GaN metal-insulator-semiconductor high electron mobility transistors (MIS-HEMTs) with different interface Si donor incorporation which is tuned during the deposition process of LPCVD-SiNx which is adopted as gate dielectric and passivation layer. Current collapse of the MIS-HEMTs without field plate is suppressed more effectively by increasing the SiH2Cl2/NH3 flow ratio and the normalized dynamic on-resistance (RON) is reduced two orders magnitude after off-state VDS stress of 600 V for 10 ms. Through interface characterization, we have found that the interface deep-level traps distribution with high Si donor incorporation by increasing the SiH2Cl2/NH3 flow ratio is lowered. It’s indicated that the Si donors are most likely to fill and screen the deep-level traps at the interface resulting in the suppression of slow trapping process and the virtual gate effect. Although the Si donor incorporation brings about the increase of gate leakage current (IGS), no clear degradation of breakdown voltage can be seen by choosing appropriate SiH2Cl2/NH3 flow ratio.