Rovian Bertinatto

Rovian Bertinatto

Auto-generated profile, based on publicly available information

Rovian Bertinatto

Universidade Federal de Santa Maria (UFSM), Brazil

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2020 in Ciência Rural
Verified
Journal Article
Open access
PDF file
JSJosé Fernando Schlosser
José Fernando Schlosser
HCHeliodoro Catalán
Heliodoro Catalán
RBRovian Bertinatto
Rovian Bertinatto
MFMarcelo Farias
Marcelo Farias
GMGuilherme Dal Mas
Guilherme Dal Mas
MCMateus Cassol Cella
Mateus Cassol Cella
Power hop is an example of self-excited vibration, characterized as a type of jump or oscillation, which alternates up and down movements in sequence, in the direction of the movement of tractors equipped with tires, resembling the galloping movement of a horse (WILEY & TURNER, 2008).

1 January 2023 in Revista Brasileira de Engenharia Agrícola E Ambiental
Verified
Journal Article
Open access
JSJosé A. Sala
José A. Sala
JSJosé F. Schlosser
José F. Schlosser
GBGilvan M. Bertollo
Gilvan M. Bertollo
DHDaniela Herzog
Daniela Herzog
RBRovian Bertinatto
Rovian Bertinatto
LRLeonardo Nabaes Romano
Leonardo Nabaes Romano
Diesel cycle engines are widely used in a wide range of agricultural activities. Recently, with the increasing use of biodiesel mixed with petroleum diesel and the introduction of pollutant emission regulations for agricultural and road machinery, there has been a growing migration from mechanical to electronic fuel injection systems. In this experiment, the primary aim was to verify the behavior of a diesel engine, electronically managed, with controlled variation of the fuel feeding system parameters (injection time and volume injected). A four-cylinder agricultural tractor with a turbocharged engine and a common rail electronic fuel injection system was used. Tests with diesel B10 and blends of 20 and 30% biodiesel were carried out, all with 10 ppm of sulfur and the injection system electronically reprogrammed. The tests were performed under full engine load from 1,300 to 2,000 rpm. The torque, power and fuel consumption were evaluated. Advancing the injection point increased the power and decreased the specific fuel consumption for all fuels. The greater amount of injected fuel provided average power gain of up to 14.96% and average torque gain of 15.50%.

1 January 2021 in Ciência Rural
Verified
Journal Article
Open access
PDF file
DHDaniela Herzog
Daniela Herzog
JSJosé Fernando Schlosser
José Fernando Schlosser
RBRovian Bertinatto
Rovian Bertinatto
MFMarcelo Farias
Marcelo Farias
LCLeonardo Casali
Leonardo Casali
The transmission system consists of a set of mechanisms capable of receiving, transforming, and transmitting the power and torque of the engine to the driving wheels, hydraulic systems, and PTO. This occurs by modifying the angular speed of the engine and, consequently, the torque in the rest of the system using the gears coupling. The gearbox is the main component of the transmission system because it is responsible for most of these changes. According to RIBAS et al. (2010), the transmission systems of tractors marketed in Brazil, despite various commercial names, fall into two categories: mechanical and hydrostatic transmissions.

1 January 2022 in Ciência Rural
Verified
Journal Article
Open access
RBRovian Bertinatto
Rovian Bertinatto
JSJosé Fernando Schlosser
José Fernando Schlosser
DHDaniela Herzog
Daniela Herzog
GBGilvan Moisés Bertollo
Gilvan Moisés Bertollo
GMGuilherme Dal Mas
Guilherme Dal Mas
JOJunior Garlet Osmari
Junior Garlet Osmari
Partial fuel replacement strategies arising from fossil sources used in compression ignition engines involve mixtures of mineral Diesel oil, biodiesel and ethanol to minimize the gas emissions. In this study, experimental assessments were performed on a multi-cylinder, turbocharged aftercooler, compression-ignition, agricultural tractor engine provided with electronic injection management and an exhaust gas recirculation (EGR) gas treatment system. Diesel oil containing low (BS10 -10 ppm) and high sulfur concentrations (BS500 - 500 ppm) was utilized, with 10% of biodiesel as a constituent established by Brazilian legislation, in blends with 5, 10, 15 and 20% of the total volume, made up of anhydrous ethanol with additives. Thus, there were eight fuels blends and two reference conditions (without ethanol). The emissions of CO, HC, NOx and the HC+NOx gases were estimated, corresponding to the eight operating modes (M) of the ABNT NBR ISO 8178-4 standard. From the findings, it was evident that with the rise in the ethanol concentrations in the fuel blends there was a corresponding increasing in the CO, NOx and HC+NOx emissions. The HC, on the contrary, exhibited a pattern of higher emissions for the high-sulfur fuels (BS500) at low loads. No difference was observed for the NOx emissions at high loads. In the other operation modes, different behaviors were expressed for the BS10, which sometimes showed an increase, while at other times a reduction in the NOx emissions. Regarding the BS500, the NOx emission increased when the ethanol concentrations rose. As the specific emissions of the NOx were higher than those of the HC (in g.kW-1.h-1), the behavior exhibited by the HC+NOx showed similarity to that of the NOx. When the directly analysis of the operating modes was taken into consideration, the use of ethanol triggered an upswing in the emissions, exceeding the threshold of MAR-1 and EURO V standards.

1 January 2022 in Ciência Rural
Verified
Journal Article
Open access
RBRovian Bertinatto
Rovian Bertinatto
JSJosé Fernando Schlosser
José Fernando Schlosser
GBGilvan Moisés Bertollo
Gilvan Moisés Bertollo
DHDaniela Herzog
Daniela Herzog
LCLeonardo Casali
Leonardo Casali
HBHalan Gabriel Borsatto
Halan Gabriel Borsatto
Over the past few years, changes have been observed in the behavior of typical performance curves, after higher technology has been incorporated into the agricultural tractor engines, either to satisfy the ceiling of the new pollutant gas emission limits or to achieve better efficiency. The aim of this study was to assess the typical performance behavior of an agricultural tractor engine, possessing electronic injection management, turbocharger, aftercooler and EGR (Exhaust Gas Recirculation) treatment system. An analysis was done of the information the manufacturers provided, in terms of nominal power, maximum power and maximum power with Booster, maximum torque and maximum torque with Booster. From the results, the percentage difference between the nominal power and maximum power were found to hover anywhere from 1.49 to 11.97%, for the same manufacturer, 0% in another manufacturer and 9% in a third manufacturer, for all the models. Similar results were noted for the data reported on the maximum torque and maximum torque with Booster, giving 0.62% as the minimum value, 7.44% as the average value and 12.65% as the maximum value for the entire series.

1 January 2024 in Ciência Rural
Verified
Journal Article
Open access
PDF file
GBGilvan Moisés Bertollo
Gilvan Moisés Bertollo
JSJosé Fernando Schlosser
José Fernando Schlosser
RBRovian Bertinatto
Rovian Bertinatto
AMAlfran Tellechea Martini
Alfran Tellechea Martini
MFMarcelo Farias
Marcelo Farias
Controlled machinery traffic is a technique to increase the efficiency of machines and make better use of inputs. This study evaluated the pollutant gas emissions of an agricultural tractor towing a precision seeder-fertilizer with different plow configurations in an area with varying intensities of controlled machinery traffic. The study was carried out in a commercial agricultural area located in the municipality of Carazinho, Brazil. The experimental design was of randomized 3 x 3 blocks, with three traffic situations (tractor traffic; tractor + harvester traffic; and tractor + harvester + sprayer traffic), as well as three plow settings. The pollutant gases analyzed were: particulate material (PM), nitrogen oxides (NOx), carbon dioxide (CO2), and oxygen (O2). We concluded that greater controlled traffic intensity, compared to an area without traffic, yields a PM reduction of 43% using the double disk, and 67% using the double disk without a ridge plow. The absence of plows on the traffic lines reduces the PM, NOx, and CO2 emissions by, respectively, 73%, 12%, and 17% with tractor + harvester traffic; and 80%, 12%, and 15% with tractor + harvester + sprayer traffic, compared to cultivation using ridge plows.