30 June 2021 in Journal of Materials and Physical Sciences
Structural properties of Zr-Al substituted M-type of barium hexaferrites, having compositions Ba1-xZr0.5xAl0.3Fe11.7O19, (x= 0.0, 0.1, 0.2, 0.3, 0.4, 0.5) are studied, which were synthesized by using co-precipitation method. These prepared samples are characterized by X-RAY diffraction (XRD) to confirm hexaferrites structure. Fourier transform infrared spectroscopy is used to make tetrahedral (higher frequency band) and octahedral (lower frequency band) clusters of metal oxides in hexaferrites and confirmed the formation of hexaferrites structure. (FESEM) Field emission scanning electron microscopy was used to give micrographs to show that grains are platelet like shaped, which agrees very well with hexaferrites structure. The particle morphology is observed to be porous and non-uniform. The grain size is decreased initially, and then increased with Zirconium additions. Scherer’s formula is applied to calculate particle size, which is observed to change in the range of 18.86 nm-9.43 nm. The grains are bounded together due to interfacial surface tension forces. The optical properties are also studied by UV Vis spectrometer to find the energy band gap, in the range of 2.09ev - 5.15ev and absorbance peak having the range 237.9nm - 252.13nm. This change in energy band gap and absorbance peak is due to the change in the grain size on the zirconium substitution.
30 June 2022 in Journal of Materials and Physical Sciences
This work carried out the study of Co0.5Zn0.5Bi0.4-xPr0.1Fe1.5+xO4 spinel ferrite series (x = 0,0.1, 0.2, 0.3 and 0.4) prepared via micro-emulsion route. Effects on structural, electrical, optical and morphology properties is studied by varying Bi concentration (x = 0,0.1, 0.2, 0.3 and 0.4). The characterization techniques employed included X-ray diffraction (XRD), scanning electron microscope (SEM), UV-visible spectroscopy and Fourier transform infrared spectroscopy (FTIR). XRD results confirmed the spinel structure having lattice parameter around 8.39 Å and particle size decreased from 30 nm to 41 nm with increasing Bi concentration. Fourier transform infrared spectroscopy (FTIR) revealed fingerprints of metal oxides band at 408-577 cm-1. Optical properties were studied UV-visible spectroscopy and Eg was found to vary from 2.83 eV to 2.59 eV. The scanning electron microscope (SEM) described the morphology of the samples. We then examine the results and the material's characteristics, as well as the areas in which it can be used.
31 December 2020 in Journal of Materials and Physical Sciences
Terbium doped magnesium spinel ferrites (Mg1-xTbxFe2O4) with composition x=0.12, 0.14, 0.16, 0.18 were synthesized via micro-emulsion method followed by synthesis of PVA/Mg1-xTbxFe2O4 composites using in-situ polymerization technique. The structural properties were evaluated using X-ray diffraction (XRD) and Fourier transform infra-red spectroscopy (FTIR). XRD analysis confirmed the construction of spinel lattice of terbium ferrite whereas FTIR revealed the interactions between ferrite nanoparticles and polyvinyl alcohol matrix. The XRD and FTIR results quite matched with the reported literature. The dielectric and resistivity analyses were performed by determining dielectric parameters and current-voltage measurements. The values of dielectric constant, dielectric loss and tan ? were found to be inversely proportional to the frequency under the ambient electric field at room temperature but became constant at higher frequency values. The lower values of dielectric constant of terbium incorporated magnesium ferrite polymer composites (MgFe2O4/PVA) are attributed to hindrance in ‘electron exchange mechanism’ created by lockup between iron and terbium ions. The resistivity values of all the composites were found from 2.5x109 ?cm to 18.8x109 ?cm which showed a non- linear behavior.