3 July 2017 in IEEE Geoscience and Remote Sensing Letters
Multiple azimuth channels are usually employed to overcome the inherent limitation between high resolution and wide swath in synthetic aperture radar systems. However, unavoidable channel phase errors will significantly degrade the performance of ambiguity suppression. Conventional calibration methods usually regard these phase errors as constants during the whole observation time and ignore the azimuth-variant phase errors, which may not totally suppress azimuth ambiguities especially for very strong targets. This letter presents an azimuth-variant phase error calibration technique. The proposed technique first selects a strong point-like target as the calibration source. Then, the azimuth-variant phase errors can be estimated by comparing the phase of the calibration source and the corresponding steering vector in the range-compressed signals. Besides, a preprocessing method is presented to improve the calibration accuracy when the selected calibration source is affected by noise or interferences. Theoretical analysis and experiments demonstrate the feasibility of the proposed technique.
4 May 2017 in IEEE Geoscience and Remote Sensing Letters
Multichannel synthetic aperture radar (SAR) signal reconstruction methods can effectively suppress azimuth ambiguities and achieve high-resolution wide-swath imaging. However, due to the characteristics of the practical antenna patterns, there exist non-bandlimited Doppler spectra, which will result in residual azimuth ambiguities, especially for strong targets. This letter presents a novel method for the suppression of the azimuth ambiguities of the strong point-like targets. First, we find out the positions of the strong point-like targets from the multichannel reconstructed SAR image. Then, we locate the ambiguous range history of each strong point-like target. Finally, the ambiguous components in the range history are filtered out by an orthogonal projection method. Therefore, the spectra of the strong point-like targets will be converted into the bandlimited spectra, and then, the azimuth ambiguities can be effectively suppressed by the conventional multichannel SAR signal reconstruction methods. Theoretical analysis and experiments demonstrate the feasibility of the proposed methods.
1 July 2016 in Journal of Applied Remote Sensing
A spectrum reconstruction algorithm based on space–time adaptive processing (STAP) can effectively suppress azimuth ambiguity for multichannel synthetic aperture radar (SAR) systems in azimuth. However, the traditional STAP-based reconstruction approach has to estimate the covariance matrix and calculate matrix inversion (MI) for each Doppler frequency bin, which will result in a very large computational load. In addition, the traditional STAP-based approach has to know the exact platform velocity, pulse repetition frequency, and array configuration. Errors involving these parameters will significantly degrade the performance of ambiguity suppression. A modified STAP-based approach to solve these problems is presented. The traditional array steering vectors and corresponding covariance matrices are Doppler-variant in the range-Doppler domain. After preprocessing by a proposed phase compensation method, they would be independent of Doppler bins. Therefore, the modified STAP-based approach needs to estimate the covariance matrix and calculate MI only once. The computation load could be greatly reduced. Moreover, by combining the reconstruction method and a proposed adaptive parameter estimation method, the modified method is able to successfully achieve multichannel SAR signal reconstruction and suppress azimuth ambiguity without knowing the above parameters. Theoretical analysis and experiments showed the simplicity and efficiency of the proposed methods.
1 August 2018 in Electronics Letters
For conventional multichannel synthetic aperture radar (SAR) systems, the pulse repetition frequency is greater than the azimuth Doppler bandwidth. Therefore, each receive channel can obtain unambiguous SAR image and the moving target usually overlaps with no more than one clutter. However, for high‐resolution wide‐swath (HRWS) SAR systems, the PRF is usually much less than the Doppler bandwidth and thus the moving target may overlap with quite a few clutters, which will severely affect the estimation of the radial velocity of the moving target. A novel radial velocity estimation method based on maximum likelihood estimation (MLE) for HRWS SAR systems is presented. Even if the moving target overlaps with quite a few clutters, the proposed MLE method can still effectively estimate the radial velocity. In order to reduce the computational load, the proposed method transforms the multi‐dimensional spectral peak searching of MLE into one‐dimensional peak searching and reduces the times of matrix inversion by a block matrix method. Theoretical analysis and experiments demonstrate the feasibility of the proposed method.
1 January 2017 in Journal of Applied Remote Sensing
Multichannel synthetic aperture radar systems are usually employed to suppress azimuth ambiguity and realize high-resolution wide-swath imaging. However, unavoidable array errors will significantly degrade the performance of ambiguity suppression and imaging quality. This paper presents an array error estimation method based on cross correlation. First, unambiguous Doppler spectra are obtained by selecting a short length of range profiles from strong targets. Then, array errors are estimated by a proposed cross-correlation method. Finally, a preprocessing method to improve the estimation accuracy is proposed. The proposed method takes full advantage of the training samples from strong targets and estimates array errors by the coherent integration technique, which improves the estimation accuracy and robustness. Theoretical analysis and experiments based on simulations and measurements showed the validity of the proposed method, especially in low signal-to-noise ratios.