Stephan Schönecker

Stephan Schönecker

Auto-generated profile, based on publicly available information

Stephan Schönecker

Applied Materials Physics, Department of Materials Science and Engineering, KTH-Royal Institute of Technology, Stockholm SE-10044, Sweden

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 July 2017 in Physical Review B
Verified
Journal Article
Closed access
PDF file
AWAnja U.B. Wolter
Anja U.B. Wolter
LCL. T. Corredor
L. T. Corredor
LJL. Janssen
L. Janssen
KNK. Nenkov
K. Nenkov
SSS. Schönecker
S. Schönecker
BBB. Büchner
B. Büchner
α−RuCl3 has attracted enormous attention since it has been proposed as a prime candidate to study fractionalized magnetic excitations akin to Kitaev's honeycomb-lattice spin liquid. We have performed a detailed specific-heat investigation at temperatures down to 0.4K in applied magnetic fields up to 9T for fields parallel to the ab plane. We find a suppression of the zero-field antiferromagnetic order, together with an increase of the low-temperature specific heat, with increasing field up to μ0Hc≈6.9 T. Above Hc, the magnetic contribution to the low-temperature specific heat is strongly suppressed, implying the opening of a spin-excitation gap. Our data point toward a field-induced quantum critical point at Hc; this is supported by universal scaling behavior near Hc. Remarkably, the data also reveal the existence of a small characteristic energy scale well below 1 meV, above which the excitation spectrum changes qualitatively. We relate the data to theoretical calculations based on a J1−K1−Γ1−J3 honeycomb model.

1 August 2016 in Materials & Design
Verified
Journal Article
Closed access
SHShuo Huang
Shuo Huang
WLWei Li
Wei Li
XLXiaoqing Li
Xiaoqing Li
SSStephan Schönecker
Stephan Schönecker
LBLars Bergqvist
Lars Bergqvist
LVLevente Vitos
Levente Vitos

1 August 2018 in Surface Science
Verified
Journal Article
Closed access
JLJ.-Y. Lee
J.-Y. Lee
MPM.P.J. Punkkinen
M.P.J. Punkkinen
SSS. Schönecker
S. Schönecker
ZNZ. Nabi
Z. Nabi
KKK. Kádas
K. Kádas
SKS.K. Kwon
S.K. Kwon

6 October 2015 in Scientific Reports
Verified
Journal Article
Open access
PDF file
SSStephan Schönecker
Stephan Schönecker
XLXiaoqing Li
Xiaoqing Li
BJBörje Johansson
Börje Johansson
SKSe Kyun Kwon
Se Kyun Kwon
LVLevente Vitos
Levente Vitos
Absolute values of surface energy and surface stress of solids are hardly accessible by experiment. Here, we investigate the temperature dependence of both parameters for the (001) and (110) surface facets of body-centered cubic Fe from first-principles modeling taking into account vibrational, electronic and magnetic degrees of freedom. The monotonic decrease of the surface energies of both facets with increasing temperature is mostly due to lattice vibrations and magnetic disorder. The surface stresses exhibit nonmonotonic behaviors resulting in a strongly temperature dependent excess surface stress and surface stress anisotropy.

3 August 2016 in Journal of Physics: Condensed Matter
Verified
Journal Article
Closed access
PDF file
RLRuihuan Li
Ruihuan Li
SLSong Lu
Song Lu
DKDongyoo Kim
Dongyoo Kim
SSStephan Schönecker
Stephan Schönecker
JZJijun Zhao
Jijun Zhao
LVLevente Vitos
Levente Vitos
The formation energy of the interface between face-centered cubic (fcc) and hexagonal close packed (hcp) structures is a key parameter in determining the stacking fault energy (SFE) of fcc metals and alloys using thermodynamic calculations. It is often assumed that the contribution of the planar fault energy to the SFE has the same order of magnitude as the bulk part, and thus the lack of precise information about it can become the limiting factor in thermodynamic predictions. Here, we differentiate between the interfacial energy for the coherent fcc(1 1 1)/hcp(0 0 0 1) interface and the ‘pseudo-interfacial energy’ that enters the thermodynamic expression for the SFE. Using first-principles calculations, we determine the coherent and pseudo-interfacial energies for six elemental metals (Al, Ni, Cu, Ag, Pt, and Au) and three paramagnetic Fe–Cr–Ni alloys. Our results show that the two interfacial energies significantly differ from each other. We observe a strong chemistry dependence for both interfacial energies. The calculated pseudo-interfacial energies for the Fe–Cr–Ni steels agree well with the available literature data. We discuss the effects of strain on the description of planar faults via thermodynamic and ab initio approaches.

22 July 2015 in Scientific Reports
Verified
Journal Article
Open access
XLXiaoqing Li
Xiaoqing Li
FTFuyang Tian
Fuyang Tian
SSStephan Schönecker
Stephan Schönecker
JZJijun Zhao
Jijun Zhao
LVLevente Vitos
Levente Vitos
Recently developed high-entropy alloys (HEAs) consisting of multiple principal elements represent a new field of metallurgy and have demonstrated appealing properties for a wide range of applications. Usingab initioalloy theory, we reveal the alloying effect on the elastic properties and the ideal tensile strength (ITS) in the [001] direction of four body-centered cubic (bcc) refractory HEAs based on Zr, V, Ti, Nb and Hf. We find that these HEAs show high elastic anisotropy and large positive Cauchy pressure, suggesting good extrinsic ductility. Starting from ZrNbHf, it is found that the ITS decreases with equimolar Ti addition. On the other hand, if both Ti and V are added to ZrNbHf, the ITS is enhanced by about 42%. An even more captivating effect is the ITS increase by about 170%, if Ti and V are substituted for Hf. The alloying effect on the ITS is explained by thed-band filling. An intrinsic brittle-to-ductile transition is found in terms of the failure mode under uniaxial tension. These investigations suggest that intrinsically ductile HEAs with high ideal strength can be achieved by controlling the proportion of group four elements to group five elements.