Motivated by the unprecedented thermoelectric performance of SnSe, we report its band structure calculations, based on density functional theory using the full potential linearized augmented plane wave. These calculations were further extended to evaluate the electrical transport properties using Boltzmann transport theory and the results were compared with the as-synthesized polycrystalline counterpart, which was synthesized employing conventional vacuum melting technique followed by consolidation employing spark plasma sintering. The as-synthesized SnSe was thoroughly characterized employing XRD, FESEM and TEM for phase purity, morphology and structure. The theoretically predicted band gap values and the temperature dependence of the electrical transport properties of SnSe were in reasonable agreement with the experimental results, within the approximations employed in our theoretical calculations. These theoretical calculations suggested that the optimum thermoelectric performance in SnSe is expected to occur at a hole doping concentration of ∼3 to 5 × 1021 cm−3. The measured fracture toughness and hardness of SnSe were found to be ∼0.76 ± 0.05 MPa √m and 0.27 ± 0.05 GPa, respectively, which are comparable with other state-of-the-art thermoelectric materials. The high value of thermal shock resistance ∼252 ± 9 W m−1, coupled with its good mechanical properties suggests SnSe to be a potential material for thermoelectric device applications.
21 December 2022 in ACS Applied Materials & Interfaces
Band engineering is a promising approach that proved successful in enhancing the thermoelectric performance of several families of thermoelectric materials. Here, we show how this mechanism can be induced in the p-type TiCoSbhalf-Heusler (HH) compound to effectively improve the Seebeck coefficient. Both the Pisarenko plot and electronic band structure calculations demonstrate that this enhancement is due to increased density-of-states effective mass resulting from the convergence of two valence band maxima. Our calculations evidence that the valence band maximum of TiCoSb lying at the Γ point exhibits a small energy difference of 51 meV with respect to the valence band edge at the L point. Experimentally, this energy offset can be tuned by both Fe and Sn substitutions on the Co and Sb site, respectively. A Sn doping level as low as x = 0.03 is sufficient to drive more than ∼100% increase in the power factor at room temperature. Further, defects at various length scales, that include point defects, edge dislocations, and nanosized grains evidenced by electron microscopy (field emission scanning electron microscopy (FESEM) and high-resolution transmission electron microscopy (HRTEM)), result in enhanced phonon scattering which substantially reduces the lattice thermal conductivity to ∼4.2 W m-1 K-1 at 873 K. Combined with enhanced power factor, a peak ZT value of ∼0.4 was achieved at 873 K in TiCo0.85Fe0.15Sb0.97Sn0.03. In addition, the microhardness and fracture toughness were found to be enhanced for all of the synthesized samples, falling in the range of 8.3-8.6 GPa and 1.8-2 MPa·m-1/2, respectively. Our results highlight how the combination of band convergence and microstructure engineering in the HH alloy TiCoSb is effective for tuning its thermoelectric performance.