Composite materials offer very interesting mechanical and physical properties. Recently, they are an increasingly sought-after commodity particularly in the military, aerospace and automotive industries. This is mainly due to the ratio between their weight and the high values of their mechanical properties, which often reach higher values than commonly used materials. This article is focused on milling of composite materials, specifically fiber reinforced plastics produced by filament winding, in terms of cutting conditions which can be used for good surface quality. The proposal of technology, such as determination of cutting conditions, is a very difficult issue because there are many problems with delamination of reinforcement, high tool wear and with filtering of powder which is formed from the chips of these materials
This article is focused on the influence of the work environment and values of cutting conditions on tool wear in machining of nickel – based super alloys. These materials are popular in the aerospace industry and in other demanding applications, due to their excellent mechanical properties. Machining of these materials brings many problems mainly due to their high strength at high temperatures, low thermal conductivity, high hardness and work hardening. Therefore it is necessary to reduce the influence of these factors on the tool, for example by changing the cutting conditions or optimization of cutting environment. The problems with the machining of these super alloys are described. The next part is focused on the experiment where the cutting process and cutting tool wear were evaluated. For the test a milling cutter with indexable inserts was used. During the test the cutting speed and feed rate was changed
This work deals with the problematics of cutting forces when drilling holes in Inconel 718. Drills with different geometries of cutting edge were used. The cutting forces and torques were measured during the experiment. The feed cutting force ...
3D printing of metallic powders is a relatively new but increasingly used technology in a wide range of sectors. Design engineers are responding flexibly to new opportunities for production and components for 3D printing and are designing with...
This work deals with the problematics of 3D printing. Additive manufacturing (AM) covers a lot of principles of producing products and prototypes, for example, Direct Metal Laser Sintering (DMLS). This principle is based on sintering metal pow...