A new method for shockless compression and acceleration of solid materials is presented. A plasma reservoir pressurized by a laser-driven shock unloads across a vacuum gap and piles up against an Al sample thus providing the drive. The rear surface velocity of the Al was measured with a line VISAR, and used to infer load histories. These peaked between and 0.5 Mbar with strain rates . Detailed simulations suggest that apart from surface layers the samples can remain close to the room temperature isentrope. The experiments, analysis, and future prospects are discussed.
An experimental study of the magnetic field distribution in gas-puff pinches with and without a preembedded axial magnetic field () is presented. Spatially resolved, time-gated spectroscopic measurements were made at the Weizmann Institute of Science on a 300 kA, 1.6 μs rise time pulsed-power driver. The radial distribution of the azimuthal magnetic field, , during the implosion, with and without a preembedded axial magnetic field of , was measured using Zeeman polarization spectroscopy. The spectroscopic measurements of were consistent with the corresponding values of inferred from current measurements made with a B-dot probe. One-dimensional magnetohydrodynamic simulations, performed with the code trac-ii, showed agreement with the experimentally measured implosion trajectory, and qualitatively reproduced the experimentally measured radial profiles during the implosion when was applied. Simulation results of the radial profile of without a preembedded axial magnetic field did not qualitatively match experimental results due to magneto-Rayleigh-Taylor (MRT) instabilities. Our analysis emphasizes the importance of MRT instability mitigation when studying the magnetic field and current distributions in pinches. Discrepancies of the simulation results with experiment are discussed.
We describe the development of an extreme ultraviolet (EUV) light source using a discharged produced plasma. The source uses a xenon plasma in a Z-pinch configuration to produce 13.5 nm ± 1% bandwidth radiation. The source is used in the semiconductor industry for metrology, mask inspection, and resist development. Based on the previously developed inductively coupled Z-pinch design, this improved source uses an innovative transistor-based switching system that overcomes the limitations of traditional magnetically switched systems. With this configuration, which includes a pre-ionization stage and direct xenon fueling, both repetition rate and energy per pulse can be greatly increased. Consequently, EUV radiation output, measured in brightness or power, can be also be increased. We describe the driver for this system and the resulting performance.