The device physics and electrical characteristics of the germanium (Ge) tunneling field-effect transistor (TFET) are investigated for high performance and low power logic applications using two dimensional device simulation. Due to the high band-to-band tunneling rate of Ge as compared to Si, the Ge TFET suffers from excessive off-state leakage current Ioff despite its higher on-state current Ion. It is shown for the first time that the high off-state leakage due to the drain-side tunneling in the Ge TFET can be effectively suppressed by controlling the drain doping concentration. A lower drain doping concentration reduces the electric field and increases the tunneling barrier width in the drain side, giving a significantly reduced off-state leakage. To increase Ion with a steeper subthreshold swing S, source doping concentration is increased to reduce the bandgap and narrow the tunneling width. Device design and physics detailing the impact of drain and source engineering on the performance of Ge TFET are discussed.
The device physics of the double-gate tunneling field-effect transistor (DG TFET) is explored through two dimensional device simulations. The on-state drain current Ion of the DG TFET, which is based on band-to-band tunneling, has a strong dependence on the silicon film thickness TSi and the physics governing it is detailed. It is established that band-to-band tunneling at the surface is very strong and accounts for a large part of the total drain current. However, a substantial part of the total drain current Ids is contributed by a subsurface portion of the silicon film. Detailed potential distributions show that the coupling of two gate electrodes in the DG TFET could effectively reduce the tunneling width ωT at the center of the silicon film up to an optimum TSi where maximum drain current is obtained.
We report high-speed photo detection at two-micron-wavelength achieved by a GeSn/Ge multiple-quantum-well (MQW) p-i-n photodiode, exhibiting a 3-dB bandwidth (f3-dB) above 10 GHz for the first time. The epitaxy of device layer stacks was performed on a standard (001)-oriented 300 mm Si substrate by using reduced pressure chemical vapor deposition (RPCVD). The results showed promise for large-scale manufacturing. To our knowledge, this is also the first photodiodes-on-Si with direct radio-frequency (RF) measurement to quantitatively confirm high-speed functionality with tens of GHz f3-dB at 2 µm, which is considered as a promising candidate for the next data communication window. This work illustrates the potential for using GeSn to extend the utility of Si photonics in 2 µm band integrated optical transceivers for communication applications.
In this letter, we report a new approach to treat the 2-D nonlinear Poisson's equation in the context of MOS devices and discuss its application in the modeling of tunneling field-effect transistors (T-FET). It is revealed that the narrowing of tunneling barrier in T-FET has different mechanisms before and after inversion layer is formed. Closed-form equation is obtained to describe the barrier narrowing in the presence of inversion layer.
We report the demonstration of a germanium-tin (Ge0.9Sn0.1) multiple-quantum-well p-i-n photodiode on silicon (Si) substrate for 2 μm-wavelength light detection. Characterization of the photodetector in both direct current (DC) and radio frequency (RF) regimes was performed. At the bias voltage of −1 V, a dark current density of 0.031 A/cm2 is realized at room-temperature, which is among the lowest reported values for Ge1−xSnx-on-Si p-i-n photodiodes. In addition, for the first time, a 3 dB bandwidth (f3dB) of around 1.2 GHz is achieved in Ge1−xSnx photodetectors operating at 2 μm. It is anticipated that further device optimization would extend the f3dB to above 10 GHz.
We demonstrate that a complementary metal-oxide-semiconductor (CMOS) compatible silicon (Si) surface passivation technique effectively suppress the dark current originating from the mesa sidewall of the Ge0.95Sn0.05 on Si (Ge0.95Sn0.05/Si) p-i-n photodiode. Current-voltage (I-V) characteristics show that the sidewall surface passivation technique could reduce the surface leakage current density (Jsurf) of the photodiode by ~100 times. A low dark current density (Jdark) of 0.073 A/cm2 at a bias voltage of −1 V is achieved, which is among the lowest reported values for Ge1-xSnx/Si p-i-n photodiodes. Temperature-dependent I-V measurement is performed for the Si-passivated and non-passivated photodiodes, from which the activation energies of dark current are extracted to be 0.304 eV and 0.142 eV, respectively. In addition, the optical responsivity of the Ge0.95Sn0.05/Si p-i-n photodiodes to light signals with wavelengths ranging from 1510 nm to 1877 nm is reported.