Jacques A. Delettrez

Jacques A. Delettrez

Auto-generated profile, based on publicly available information

Jacques A. Delettrez

Laboratory for Laser Energetics, University of Rochester, Rochester, New York 14623, USA

Research Focus & Metrics

Academic Career Length

45Years (1982-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 April 2001 in Physics of Plasmas
Verified
Journal Article
Open access
PDF file
DMD. D. Meyerhofer
D. D. Meyerhofer
JDJ. A. Delettrez
J. A. Delettrez
RER. Epstein
R. Epstein
VGV. Yu. Glebov
V. Yu. Glebov
VGV. N. Goncharov
V. N. Goncharov
TST. C. Sangster
T. C. Sangster
The performance of gas-filled, plastic-shell implosions has significantly improved with advances in on-target uniformity on the 60-beam OMEGA laser system [T. R. Boehly, D. L. Brown, R. S. Craxton et al., Opt. Commun. 133, 495 (1997)]. Polarization smoothing (PS) with birefringent wedges and 1-THz-bandwidth smoothing by spectral dispersion (SSD) have been installed on OMEGA. The beam-to-beam power imbalance is ⩽5% rms. Implosions of 20-μm-thick CH shells (15 atm fill) using full beam smoothing (1-THz SSD and PS) have primary neutron yields and fuel areal densities that are ∼70% larger than those driven with 0.35-THz SSD without PS. They also produce ∼35% of the predicted one-dimensional neutron yield. The results described here suggest that individual-beam nonuniformity is no longer the primary cause of nonideal target performance. A highly constrained model of the core conditions and fuel–shell mix has been developed. It suggests that there is a “clean” fuel region, surrounded by a mixed region, that accounts for half of the fuel areal density.

25 July 2016 in Review of Scientific Instruments
Verified
Journal Article
Closed access
PDF file
RFR. K. Follett
R. K. Follett
JDJ. A. Delettrez
J. A. Delettrez
DED. H. Edgell
D. H. Edgell
RHR. J. Henchen
R. J. Henchen
JKJ. Katz
J. Katz
DFD. H. Froula
D. H. Froula
Collective Thomson scattering is a technique for measuring the plasma conditions in laser-plasma experiments. Simultaneous measurements of ion-acoustic and electron plasma-wave spectra were obtained using a 263.25-nm Thomson-scattering probe beam. A fully reflective collection system was used to record light scattered from electron plasma waves at electron densities greater than 1021 cm−3, which produced scattering peaks near 200 nm. An accurate analysis of the experimental Thomson-scattering spectra required accounting for plasma gradients, instrument sensitivity, optical effects, and background radiation. Practical techniques for including these effects when fitting Thomson-scattering spectra are presented and applied to the measured spectra to show the improvements in plasma characterization.

1 May 2018 in Physics of Plasmas
Verified
Journal Article
Closed access
PDF file
KWK. M. Woo
K. M. Woo
RBR. Betti
R. Betti
DSD. Shvarts
D. Shvarts
ABA. Bose
A. Bose
DPD. Patel
D. Patel
HAHussein Aluie
Hussein Aluie
The study of Rayleigh–Taylor instability in the deceleration phase of inertial confinement fusion implosions is carried out using the three-dimensional (3-D) radiation-hydrodynamic Eulerian parallel code DEC3D. We show that the yield-over-clean is a strong function of the residual kinetic energy (RKE) for low modes. Our analytical models indicate that the behavior of larger hot-spot volumes observed in low modes and the consequential pressure degradation can be explained in terms of increasing the RKE. These results are derived using a simple adiabatic implosion model of the deceleration phase as well as through an extensive set of 3-D single-mode simulations using the code DEC3D. The effect of the bulk velocity broadening on ion temperature asymmetries is analyzed for different mode numbers ℓ=1 –12. The jet observed in low mode ℓ=1 is shown to cause the largest ion temperature variation in the mode spectrum. The vortices of high modes within the cold bubbles are shown to cause lower ion temperature variations than low modes.

23 April 2002 in Physics of Plasmas
Verified
Journal Article
Closed access
PDF file
CSC. Stoeckl
C. Stoeckl
CCC. Chiritescu
C. Chiritescu
JDJ. A. Delettrez
J. A. Delettrez
RER. Epstein
R. Epstein
VGV. Yu. Glebov
V. Yu. Glebov
TPT. W. Phillips
T. W. Phillips
Initial results from direct-drive spherical cryogenic target implosions on the 60-beam OMEGA laser system [T. R. Boehly, D. L. Brown, R. S. Craxton et al., Opt. Commun. 133, 495 (1997)] are presented. These experiments are part of the scientific base leading to direct-drive ignition implosions planned for the National Ignition Facility (NIF) [W. J. Hogan, E. I. Moses, B. E. Warner et al., Nucl. Fusion 41, 567 (2001)]. Polymer shells (1-mm diam with walls <3 μm) are filled with up to 1000 atm of D2 to provide 100-μm-thick ice layers. The ice layers are smoothed by IR heating with 3.16-μm laser light and are characterized using shadowgraphy. The targets are imploded by a 1-ns square pulse with up to ∼24 kJ of 351-nm laser light at a beam-to-beam rms energy balance of <3% and full-beam smoothing. Results shown include neutron yield, secondary neutron and proton yields, the time of peak neutron emission, and both time-integrated and time-resolved x-ray images of the imploding core. The experimental values are compared with 1-D numerical simulations. The target with an ice-layer nonuniformity of σrms=9 μm showed 30% of the 1-D predicted neutron yield. These initial results are encouraging for future cryogenic implosions on OMEGA and the NIF.

23 April 2002 in Physics of Plasmas
Verified
Journal Article
Closed access
PDF file
PRP. B. Radha
P. B. Radha
JDJ. Delettrez
J. Delettrez
RER. Epstein
R. Epstein
VGV. Yu Glebov
V. Yu Glebov
RKR. Keck
R. Keck
TPT. W. Phillips
T. W. Phillips
Direct-drive implosions on the OMEGA laser [T. R. Boehly, D. L. Brown, R. S. Craxton et al., Opt. Commun. 133, 495 (1997)] have been diagnosed using a wide range of techniques based on neutrons, charged particles, and x rays. These implosions use full single-beam smoothing (distributed phase plates, 1-THz-bandwidth smoothing by spectral dispersion and polarization smoothing). The beam-to-beam power imbalance is ⩽5%. Fuel areal densities close to those in one-dimensional (1-D) simulations are inferred for implosions with calculated convergence ratios ∼15. The experimental neutron yields are ∼35% of 1-D yields. The complementary nature of the experimental observables is exploited to infer fuel shell mix in these implosions. Data suggest that this mix occurs at relatively small scales. Analysis of the experimental observables results in a picture of the core and mix region indicating that nearly 70% of the compressed fuel areal density is unmixed, and about 20% of the compressed shell areal density is in the mixed region. Comparisons of this model with inferred core conditions from argon-doped implosions are also presented.

19 April 2016 in Physics of Plasmas
Verified
Journal Article
Closed access
PDF file
PRP. B. Radha
P. B. Radha
MHM. Hohenberger
M. Hohenberger
DED. H. Edgell
D. H. Edgell
JMJ. A. Marozas
J. A. Marozas
FMF. J. Marshall
F. J. Marshall
AZA. Zylstra
A. Zylstra
Direct-drive implosion physics is being investigated at the National Ignition Facility. The primary goal of the experiments is twofold: to validate modeling related to implosion velocity and to estimate the magnitude of hot-electron preheat. Implosion experiments indicate that the energetics is well-modeled when cross-beam energy transfer (CBET) is included in the simulation and an overall multiplier to the CBET gain factor is employed; time-resolved scattered light and scattered-light spectra display the correct trends. Trajectories from backlit images are well modeled, although those from measured self-emission images indicate increased shell thickness and reduced shell density relative to simulations. Sensitivity analyses indicate that the most likely cause for the density reduction is nonuniformity growth seeded by laser imprint and not laser-energy coupling. Hot-electron preheat is at tolerable levels in the ongoing experiments, although it is expected to increase after the mitigation of CBET. Future work will include continued model validation, imprint measurements, and mitigation of CBET and hot-electron preheat.