The article presents the results of research on the peculiarities of improving the quality of seeds during their sorting by specific gravity on a pneumatic table in the process of pre-sowing preparation of winter wheat seeds on a modern technological line. Laboratory, weighing and measuring, mathematical and statistical. Pre-sowing seed preparation was carried out with seeds of five batches of seeds selected by the Institute of Plant Physiology and Genetics of the National Academy of Sciences under different modes of pneumatic sorting table operation. Seed sorting was carried out at different angles of inclination of the sieve surface: the longitudinal angle of inclination was 1.0 º and remained unchanged, and the transverse angle was changed from 2.75 to 4.00 º. In such modes, the seeds stay on the sieve surface of the pneumatic table for the longest time and, accordingly, they are better sorted. It was established that when sorting winter wheat seeds to increase their weight of 1000 seeds and, accordingly, germination, increasing the transverse angle of the sieve surface to 4.0 º without changing the longitudinal angle provided, with insignificant seed waste (13.7 %), an increase in the weight of 1000 seeds on average by 4.9 g in varieties compared to the control - without sorting. The yield of prepared seeds depended both on the varietal characteristics and on the weight of 1000 seeds. With increasing weight of 1000 seeds, the yield of prepared seeds decreases. The highest yield ‒ 92.4 % was obtained when sorting seeds of Darinka Kyivska variety under the mode of longitudinal angle of inclination of the sieve surface of the pneumatic table 1.0 º, transverse 4.00 º, the lowest ‒ 84.0 %, of Gorodnytsia and Novosmuglianka varieties under the same sorting mode. The varieties reacted differently to the modes of sorting winter wheat seeds. Seed sorting by specific gravity on a pneumatic table during its pre-sowing preparation on the technological line of the Institute with a small waste, which averaged 13.3 % for the varieties, provided seeds with a germination rate of 97‒99 %, which was 5‒7 % higher than the requirements of the current standard. У статті наведено результати досліджень особливостей підвищення якості насіння при його сортуванні за питомою масою на пневмостолі у процесі передпосівної підготовки насіння пшениці озимої на сучасній технологічній лінії. Передпосівну підготовку насіннєвого матеріалу проводили з п’яти партій насіння селекції Інституту фізіології рослин і генетики НАН при різних режимах налаштування роботи пневматичного сортувального стола. Сортування насіння проводили при різних кутах нахилу ситової поверхні: поздовжній кут нахилу був 1,0 º і залишався без зміни, а поперечні – змінювали від 2,75 до 4,00 º. За таких режимів насіння найдовше перебуває на ситовій поверхні пневмостолу і, відповідно, краще відбувається його сортування. Встановлено, що за умови сортування насіння пшениці озимої з метою підвищення його маси 1000 насінин і, відповідно, схожості, збільшення поперечного кута нахилу ситової поверхні до 4,0 º без зміни поздовжнього кута забезпечило при незначних відходах насіння (13,7%) підвищення маси 1000 насінин у середньому по сортах на 4,9 г порівняно з контролем – без сортування. Вихід підготовленого насіння залежав як від сортових особливостей, так і від маси 1000 насінин. Зі збільшенням маси 1000 насінин зменшується вихід підготовленого насіння. Найбільший вихід – 92,4 % отримано при сортуванні насіння сорту Даринка Київська за режимом: поздовжній кут нахилу ситової поверхні пневмостолу ‒ 1,0 º, поперечний ‒ 4,00 º; найменший – 84,0 %, сортів Городниця та Новосмуглянка за умови такого ж режиму сортування. Сорти по-різному реагували на режими сортування насіння пшениці озимої. Сортування насіння за питомою масою на пневмостолі у разі передпосівної його підготовки на технологічній лінії інституту при незначному відході, який становив у середньому по сортах 13,3 %, забезпечило отримання насіння зі схожістю 97‒99 %, яка була вищою на 5‒7 % від вимог чинного стандарту.