Nurzhamal Ospanova

Nurzhamal Ospanova

Auto-generated profile, based on publicly available information

Nurzhamal Ospanova

International IT University

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 October 2025 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
MAMukhit Abdullayev
Mukhit Abdullayev
Ainur KuttybayevaAinur Kuttybayeva
Ainur Kuttybayeva
KTKalmukhamed Tazhen
Kalmukhamed Tazhen
KAKhabay Anar
Khabay Anar
NONurzhamal Ospanova
Nurzhamal Ospanova
DZDaria Zhumakhanova
Daria Zhumakhanova
The object of this study is a stratospheric airship-based telecommunication platform, employed as a high-altitude platform station (HAPS), designed to operate at altitudes of 20–30 km and provide broadband connectivity in regions with limited terrestrial infrastructure such as rural and remote areas of the Republic of Kazakhstan. The key research problem is to ensure stable connectivity of HAPS-based telecommunication platforms under strong stratospheric winds, with limited payload capacity and energy resources, while developing a scalable network architecture for multi-airship coordination. This paper proposes a network concept based on modular nano-airships, which reduces drag, enhances maintainability, and ensures continuous service. Calculations of lifting capacity, aerodynamic drag of different envelope shapes, energy balance, and the coverage radius of a single station were performed. Experimental tests of a prototype confirmed the feasibility of using the sub-GHz band (433 MHz) to provide long-range communication under ground test conditions, where signal attenuation was found to be minimal compared to higher frequencies. Due to the obtained characteristics, the hypothesis of employing a group of smaller airships instead of a single large carrier was confirmed. This is explained by their reduced sensitivity to wind loads, flexibility in network configuration, and lower operational risks. Unlike traditional satellite systems, which are expensive to launch and maintain, stratospheric airships can be recovered, repaired, and redeployed at relatively low cost, offering an economically viable solution for developing regions. The results can be applied in the creation of national communication networks for remote and sparsely populated areas of the Republic of Kazakhstan, in emergency response operations, and as a complementary layer to satellite constellations. The proposed concept demonstrates that modular HAPS networks are a realistic and scalable alternative, capable of providing broadband access under real-world atmospheric and geographic constraints


30 April 2026 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
Ainur KuttybayevaAinur Kuttybayeva
Ainur Kuttybayeva
SZSamal Zhamalova
Samal Zhamalova
ABAnargul Boranbayeva
Anargul Boranbayeva
ZMZhansaya Myrzayeva
Zhansaya Myrzayeva
GIGulnar Imasheva
Gulnar Imasheva
KTKalmukhamed Tazhen
Kalmukhamed Tazhen
The object of the study is the onboard diagnostic process in CubeSat nanosatellite systems, with particular emphasis on fault detection based on real-time analysis of multivariate telemetry data under real-time embedded operating conditions. The problem statement is the gap between the relatively low computational expenses and predictability of classical FDIR approaches and their limited ability to detect complex anomalies, and, conversely, the greater anomaly sensitivity and lower embedded performance of machine-learning models. A hybrid onboard diagnostic architecture that integrates telemetry acquisition, telemetry preprocessing, statistical feature extraction, a deterministic FDIR branch, a lightweight machine-learning branch, and decision fusion into one onboard diagnostics session has been elaborated. The proposed hybrid onboard diagnostic architecture has been evaluated based on hardware-in-the-loop testing using representative telemetry and fault cases for CubeSat systems. The evaluation metrics were the fault-detection accuracy, the detection latency, the CPU consumption, the memory consumption, and the resistance to telemetry noise. The hybrid onboard diagnostic architecture was compared to the conventional threshold-based FDIR system and standalone machine learning algorithms under the same HIL conditions. In the reported experiment setup, the proposed hybrid onboard diagnostic architecture demonstrated the fault-detection accuracy of 94%, while the classical FDIR method provided 71%, and the standalone machine-learning approach provided 88%. The average detection latency was decreased to 83 ms, in contrast to 120 ms and 95 ms, respectively. The embedded solution requires only 17.6% CPU and 58 KB of memory. Under the highest telemetry-noise level, the fault-detection accuracy of the proposed hybrid onboard diagnostic architecture decreases to 80%, whereas the standalone machine-learning and the classical FDIR baselines provide only 65% and 43% fault-detection accuracy, respectively.

28 February 2025 in Eastern-European Journal of Enterprise Technologies
Verified
Journal Article
Open access
PDF file
NONurzhamal Ospanova
Nurzhamal Ospanova
AOAigul Orazymbetova
Aigul Orazymbetova
YBYelena Bakhtiyarova
Yelena Bakhtiyarova
MLMarina Lipskaya
Marina Lipskaya
YBYerdaulet Beibit
Yerdaulet Beibit
The object of this study is fiber-optic communication lines operating under increased mechanical loads arising during cable installation, operation in aggressive environments, or on moving objects. The problem lies in the insufficient understanding of the impact of mechanical loads on the parameters of optical fibers, which complicates their use in challenging operating conditions. The aim of the work is to improve the reliability and durability of such lines by studying the effect of tensile and compressive loads on the characteristics of multimode optical fibers (MOFs). During the experiments, the initial attenuation values (1.09 dB/km) and their changes under tensile loads were measured. Test samples, approximately 20 meters long, were subjected to gradually increasing tensile force. Prolonged exposure to the load significantly increased the attenuation coefficient, particularly in the shortwave part of the spectrum. Fiber failure occurred after 113 minutes, indicating a critical reduction in strength. This effect can be attributed to the intensification of material inhomogeneities in the fiber, leading to increased light scattering. The impact of compressive loads on dispersion was studied at a wavelength of 1.06 μm. It was found that the shortwave spectrum is more sensitive to deformations due to the specific structure of the fiber. A comprehensive analysis of the loads identified critical factors affecting the reliability of MOFs. The results obtained enable the prediction of the durability of fiber-optic communication lines, accounting for mechanical impacts in their design and developing recommendations for improved operation. The practical significance lies in applying the findings to enhance fiber condition assessment methods and create more reliable communication systems