18 May 2017 in Plasma Physics and Controlled Fusion
Integrated modeling for core plasma is performed to increase confidence in the proposed baseline scenario in the 0D analysis for the China Fusion Engineering Test Reactor (CFETR). The steady-state scenarios are obtained through the consistent iterative calculation of equilibrium, transport, auxiliary heating and current drives (H&CD). Three combinations of H&CD schemes (NB + EC, NB + EC + LH, and EC + LH) are used to sustain the scenarios with q min > 2 and fusion power of ∼70–150 MW. The predicted power is within the target range for CFETR Phase I, although the confinement based on physics models is lower than that assumed in 0D analysis. Ideal MHD stability analysis shows that the scenarios are stable against n = 1–10 ideal modes, where n is the toroidal mode number. Optimization of RF current drive for the RF-only scenario is also presented. The simulation workflow for core plasma in this work provides a solid basis for a more extensive research and development effort for the physics design of CFETR.
26 November 2019 in Physical Review Letters
We report on the first direct comparisons of microtearing turbulence simulations to experimental measurements in a representative high bootstrap current fraction () plasma. Previous studies of high plasmas carried out in DIII-D with large radius internal transport barriers (ITBs) have found that, while the ion energy transport is accurately reproduced by neoclassical theory, the electron transport remains anomalous and not well described by existing quasilinear transport models. A key feature of these plasmas is the large value of the normalized pressure gradient, which is shown to completely stabilize conventional drift-wave and kinetic ballooning mode instabilities in the ITB, but destabilizes the microtearing mode. Nonlinear gyrokinetic simulations of the ITB region performed with the cgyro code demonstrate that the microtearing modes are robustly unstable and capable of driving electron energy transport levels comparable to experimental levels for input parameters consistent with the experimental measurements. These simulations uniformly predict that the microtearing mode fluctuation and flux spectra extend to significantly shorter wavelengths than the range of linear instability, representing significantly different nonlinear dynamics and saturation mechanisms than conventional drift-wave turbulence, which is also consistent with the fundamental tearing nature of the instability. The predicted transport levels are found to be most sensitive to the magnetic shear, rather than the temperature gradients more typically identified as driving turbulent plasma transport.
24 February 2017 in Nuclear Fusion
1 February 2021 in Physics of Plasmas
Internal magnetic fluctuation measurements are utilized to identify turbulence associated with micro-tearing modes (MTM) in the DIII-D Edge-Localized-Mode (ELM)-y H-mode pedestal. Using a Faraday-effect polarimeter, magnetic turbulence (150–500 kHz) is directly observed with a typical line-averaged fluctuation amplitude of ∼0.8 G at peak frequency (250 kHz) and ∼15 G integrated over the spectrum from 150 to 500 kHz. Frequency, poloidal wavenumber, and propagation direction of the magnetic turbulence all serve to identify as MTM. Magnetic turbulence amplitude non-monotonically correlates with collision frequency, peaks off mid-plane, and correlates with electron temperature gradient evolution between ELMs, consistent with MTM features identified from theory and gyro-kinetic simulation. The magnetic turbulence growth correlates with confinement degradation in ELMy H-mode plasmas during a slow density ramp. These internal measurements provide unique constraints toward developing physics understanding and validating models of the H-mode pedestal for future devices.
1 December 2020 in Physics of Plasmas
Magnetic turbulence is directly observed internally in the pedestal of ELMy H-mode tokamak plasmas using a newly developed Faraday-effect polarimetry measurement. Fluctuation amplitude is (150–500 kHz), with a ratio of magnetic to density fluctuation . Magnetic turbulence is identified as resulting from micro-tearing-instability and mode growth accompanied by degraded plasma confinement is observed.
12 October 2017 in Nuclear Fusion