4 May 2022 in IEEE Communications Surveys & Tutorials
What will the future of UAV cellular communications be? In this tutorial article, we address such a compelling yet difficult question by embarking on a journey from 5G to 6G and expounding a large number of case studies supported by original results. We start by overviewing the status quo on UAV communications from an industrial standpoint, providing fresh updates from the 3GPP and detailing new 5G NR features in support of aerial devices. We then dissect the potential and the limitations of such features. In particular, we demonstrate how sub-6GHz massive MIMO can successfully tackle cell selection and interference challenges, we showcase encouraging mmWave coverage evaluations in both urban and suburban/rural settings, and we examine the peculiarities of direct device-to-device communications in the sky. Moving on, we sneak a peek at next-generation UAV communications, listing some of the use cases envisioned for the 2030s. We identify the most promising 6G enablers for UAV communication, those expected to take the performance and reliability to the next level. For each of these disruptive new paradigms (non-terrestrial networks, cell-free architectures, artificial intelligence, reconfigurable intelligent surfaces, and THz communications), we gauge the prospective benefits for UAVs and discuss the main technological hurdles that stand in the way. All along, we distil our numerous findings into essential takeaways, and we identify key open problems worthy of further study.
12 June 2020 in IEEE Transactions on Wireless Communications
We consider a cellular network deployment where UAV-to-UAV (U2U) transmit-receive pairs share the same spectrum with the uplink (UL) of cellular ground users (GUEs). For this setup, we focus on analyzing and comparing the performance of two spectrum sharing mechanisms: (i) underlay, where the same time-frequency resources may be accessed by both UAVs and GUEs, resulting in mutual interference, and (ii) overlay, where the available resources are divided into orthogonal portions for U2U and GUE communications. We evaluate the coverage probability and rate of both link types and their interplay to identify the best spectrum sharing strategy. We do so through an analytical framework that embraces realistic heightdependent channel models, antenna patterns, and practical power control mechanisms. For the underlay, we find that although the presence of U2U direct communications may worsen the uplink performance of GUEs, such effect is limited as base stations receive the power-constrained UAV signals through their antenna sidelobes. In spite of this, our results lead us to conclude that in urban scenarios with a large number of UAV pairs, adopting an overlay spectrum sharing seems the most suitable approach for maintaining a minimum guaranteed rate for UAVs and a high GUE UL performance.
10 August 2016 in IEEE Wireless Communications Letters
In this letter, we revisit hybrid analog-digital precoding systems with emphasis on the modeling of their radio-frequency (RF) losses, to realistically evaluate their benefits in 5G system implementations. We focus on fully-connected analog beamforming networks (FC-ABFNs) and on discrete Fourier transform implementations, and decompose these as a bank of commonly used RF components. We then model their losses based on their S-parameters. Our results reveal that the performance and energy efficiency of hybrid precoding systems are severely affected once these, commonly ignored, losses are considered in the overall design. In this context, we also show that hybrid precoder designs similar to Butler matrices are capable of providing better performances than FC-ABFN for systems with a large number of RF chains.
14 June 2019 in IEEE Transactions on Wireless Communications
In this paper, we focus on the coexistence between a MIMO radar and cellular base stations. We study the interfering channel estimation, where the radar is operated in the “search and track" mode, and the BS receives the interference from the radar. Unlike the conventional methods where the radar and the cellular systems fully cooperate with each other, in this work we consider that they are uncoordinated and the BS needs to acquire the interfering channel state information (ICSI) by exploiting the radar probing waveforms. For completeness, both the line-of-sight (LoS) and Non-LoS (NLoS) channels are considered in the coexistence scenario. By further assuming that the BS has limited a priori knowledge about the radar waveforms, we propose several hypothesis testing methods to identify the working mode of the radar, and then obtain the ICSI through a variety of channel estimation schemes. Based on the statistical theory, we analyze the theoretical performance of both the hypothesis testing and the channel estimation methods. Finally, simulation results verify the effectiveness of our theoretical analysis and demonstrate that the BS can effectively estimate the interfering channel even with limited information from the radar.
14 February 2017 in IEEE Transactions on Communications
In this paper, we explore reduced-connectivity radio frequency (RF) switching networks for reducing the analog hardware complexity and switching power losses in antenna selection (AS) systems. In particular, we analyze different hardware architectures for implementing the RF switching matrices required in AS designs with a reduced number of RF chains. We explicitly show that fully-flexible switching matrices, which facilitate the selection of any possible subset of antennas and attain the maximum theoretical sum rates of AS, present numerous drawbacks such as the introduction of significant insertion losses, particularly pronounced in massive multiple-input multiple-output (MIMO) systems. Since these disadvantages make fully-flexible switching suboptimal in the energy efficiency sense, we further consider partially-connected switching networks as an alternative switching architecture with reduced hardware complexity, which we characterize in this work. In this context, we also analyze the impact of reduced switching connectivity on the analog hardware and digital signal processing of AS schemes that rely on received signal power information. Overall, the analytical and simulation results shown in this paper demonstrate that partially-connected switching maximizes the energy efficiency of massive MIMO systems for a reduced number of RF chains, while fully-flexible switching offers sub-optimal energy efficiency benefits due to its significant switching power losses.
5 October 2017 in IEEE Transactions on Antennas and Propagation
A spatially correlated large antenna array operating at millimeter-wave (mmWave) frequencies is considered. Based on a Saleh-Valenzuela channel model, closed-form expressions of the three-dimensional spatial correlation (SC) for wide, narrow and Von Mises power elevation spectra (PES) are analytically derived. The effects of the PES on the convergence to massive multipleinput- multiple-output (MIMO) properties is then illustrated by defining and deriving a diagonal dominance metric. Numerically, the effects of antenna element mutual coupling (MC) is shown on the effective SC, eigenvalue structure and mmWave user rate for different antenna topologies. It is concluded that although MC can significantly reduce SC for side-by-side dipole antenna elements, the change in antenna effective gain (and therefore signal-to-noise ratio) caused by MC becomes a dominating effect and ultimately determines the antenna array performance. The user rate of a mmWave system with hybrid beamforming (HBF), using an orthogonal matching pursuit (OMP) algorithm, is then shown for different antenna topologies with dipole and crosspolarized (x-pol) antenna elements. It is seen that even for small numbers of radio-frequency chains, the OMP algorithm works well relative to the fully digital case for channels with high SC, such as the x-pol antenna array.