14 August 2008 in Physical Review Letters
We study pattern formation during tensile deformation of confined viscoelastic layers. The use of a model system [poly(dimethylsiloxane) with different degrees of cross-linking] allows us to go continuously from a viscous liquid to an elastic solid. We observe two distinct regimes of fingering instabilities: a regime called “elastic” with interfacial crack propagation, where the fingering wavelength scales only with the film thickness, and a bulk regime called “viscoelastic,” where the fingering instability shows a Saffman-Taylor-like behavior. We find good quantitative agreement with theory in both cases and present a reduced parameter describing the transition between the two regimes and allowing us to predict the observed patterns over the whole range of viscoelastic properties.
1 December 2011 in Physics of Fluids
We present a study on pattern formation in a Newtonian liquid during lifting of a circular Hele–Shaw cell. When a confined layer of oil is subject to such a stretch flow, air penetrates into the liquid from the sides and a fingering instability, a variant of the classical Saffman–Taylor instability, evolves. This setting has the particularity that the finger growth takes place in a conserved volume of liquid and that the dimensionless surface tension, the control parameter which governs the Saffman–Taylor instability, is changing with time. This leads to a constantly evolving pattern, which we investigate with regard to number of fingers and finger amplitude. We distinguish in the pattern at each instant growing fingers and stagnant fingers. Systematically varying the properties of the viscous oil and the geometry of the Hele–Shaw cell, we show that the number of growing fingers is at each moment well described by a simple approach based on linear stability analysis and depends only on the dimensionless surface tension. In contrast, the finger amplitude and consequently the total number of fingers (growing and stagnant fingers) depend also on the cell confinement. We demonstrate that the finger amplitude has a distinct influence on the debonding force. Higher finger amplitude and number of fingers lead to lower forces.
29 September 2010 in Journal of Polymer Science Part A: Polymer Chemistry
13 October 2010 in Macromolecules
19 September 2013 in The European Physical Journal E
6 May 2010 in Soft Matter
We present the first quantitative measurement of the receding contact angle between a soft viscoelastic material and a solid surface during the debonding of the material. We developed a new method of observation, based on the technique pioneered by Yamaguchi et al. (T. Yamaguchi, K. Koike, and M. Doi, Euro. Phys. Lett., 2007, 77, 64002). In a probe-tack geometry, we obtained a 3D-like view of the debonding pattern as seen through the adhesive/probe interface, providing thus an excellent view of the details of the contact geometry near the interface. Combining visual and force-displacement information in a probe tack test, we identified three different categories of mechanisms and contact geometries as a function of the material parameters. For very weakly crosslinked viscoelastic materials around the gel point, air fingers form in the bulk of the layer. For higher degrees of crosslinking, the air fingers form and propagate at the interface, with a large deformation of the bulk of the layer. A well defined and reproducible receding contact angle φ < 90° depending on the viscoelastic properties of the layer was observed at the leading edge of the moving finger. Finally for well crosslinked samples the failure occurs by interfacial crack propagation with little deformation of the layer; the contact angle at the leading edge then was close to 90° as expected from elastic fracture mechanics.