Laboratory of Organic Physical Chemistry and Environmental Analyses, Department of Chemistry, Faculty of Sciences and Techniques, Cheikh Anta Diop University, Dakar, Senegal
Auto-generated profile, based on publicly available information
Modou Fall
Laboratory of Organic Physical Chemistry and Environmental Analyses, Department of Chemistry, Faculty of Sciences and Techniques, Cheikh Anta Diop University, Dakar, Senegal
In this study, polyaniline composite films were obtained by electrosynthesis of polyaniline (PANI) after electrodeposition of radicals generated from 4-aminobenzenesulfonic diazonium salt (ABS) on glassy carbon electrodes (GCE). The electrochemical reduction process of ABS and electropolymerization of aniline were investigated via cyclic voltammetry, electrochemical impedance spectroscopy and UV-visible absorption spectroscopy. The PANI/ABS/GCE showed higher reactivity with respect to the [Fe(CN)6]3−/[Fe(CN)6]4− redox couple as compared to the bare GCE and PANI/GCE. The surface morphology of the modified electrode, characterized by scanning electron microscopy, showed fibrous and porous nanotubes. The PANI/ABS/GCE was then applied for the detection of nitrite ions in an acidified aqueous solution. The electrode exhibited enhanced electrocatalytic activity towards the reduction of these ions. Furthermore, the modified electrode showed linear voltammetric responses towards NO2− at concentrations between 0.5 and 35 μM, with a detection limit of 0.48 μM. The sensitivity was found to be 23.04 μA μM−1 cm−2, and the relative standard deviation (RSD) was 1.67% and 4.99% for intra assay and inter assay, respectively, which indicated good reproducibility of the sensor. The stability of the PANI/ABS/GCE was investigated by periodically measuring the current response, which leveled off after 7 days and became equal to 80% of the initial value. Finally, no significant modifications in the electrode signal were noted after adding various ions (2.5 mM) to 0.1 M HCl.
Polybithiophene (PBT) films (oxidized form), electrochemically deposited on Pt from an aqueous anionic micellar medium, were characterized by EIS measurements in 0.3 M aqueous LiClO 4 at different applied potentials. The EIS data were fitted with an equivalent electrical circuit in order to characterize the PBT electrochemical properties. Our experimental results show that both the double-layer and the film capacitances as well as the charge-transfer resistance decreased with the film thickness, while the diffusive capacitance and the charge-transfer and the pore resistance increased. Increasing the applied potential enhances the double-layer and film capacitances and the charge-transfer and pore resistances, but reduces the diffusive capacitance (with a minimum around the open-circuit potential) and the film resistance.
13 July 2015 in Bulletin of the Chemical Society of Ethiopia