Gas diffusion layers (GDLs) are commonly known as one of the critical water management components in polymer electrolyte fuel cells with significant impact on the electrochemical cell performance. Increasing levels of liquid saturation in GDLs, especially during high-current-density operation, limit gas transport from the flow field channels to the catalyst layer surfaces and hence reduce cell performance. To provide GDL material selection and modification guidelines, a thorough understanding of the underlying structural factors of GDL materials and their influence on water management is required. In this work, operando X-ray tomographic microscopy (XTM) was employed to investigate the liquid saturation behavior for three commercial GDL materials during i-E curves and current jump characterization. Liquid volume fractions, saturation profiles and cluster distributions were analyzed to understand observed discrepancies in cell performance. Furthermore, saturation-dependent relative diffusivities were derived via direct numerical simulations, and the impact of GDL substrates on cell performance is thoroughly discussed with respect to structure and thermal properties.
Improvements in synchrotron based operando X-ray tomographic microscopy (XTM) of polymer electrolyte fuel cells (PEFCs) have paved the way for 4D imaging studies of the water distribution in the gas diffusion layer (GDL). In order to capture the full water dynamics in 4D, a decrease of the scan time towards 0.1 s is aspired, posing significant challenges in image processing for quantitative water detection. In this work, ex situ and in situ X-ray tomographic microscopy experiments were conducted to study the influence of imaging parameters and image denoising settings on image quality and water detectability in the GDL. The image quality is quantified for scan times between 50 ms and 12.8 s at the TOMCAT beamline of the Swiss Light Source. Denoising strategies for a broad range of image qualities were identified, which enable high in situ water detectability rate of 96% at a scan time of 1.6 s and 88% at subsecond scan time as short as 0.4 s. The presented methodology can be transferred to other PEFC or similar XTM imaging setups and image processing pipelines to verify their water detection capabilities.
1 October 2022 in Journal of the Electrochemical Society
Desaturation of polymer electrolyte fuel cells (PEFCs) is a critical operation step for providing cell cold-start performance by minimizing residual water in the gas diffusion layers (GDLs), flow field (FF) channels, catalyst layers and membrane after cell shutdown. In this work, transient liquid water removal processes in the FF channels and GDLs are visualized and quantified by subsecond in situ X-ray tomographic microscopy (XTM), and correlated to high frequency resistance (HFR) measurements of the cell. Time-resolved desaturation profiles are analyzed for three commercially available GDLs with representative substrate dimensions. The influence of different substrates on the GDL desaturation behavior is investigated with a cluster connectivity analysis and saturation-dependent effective diffusivities are determined by numerical simulations. Characteristic drying phases are identified for the HFR curves and confirmed with XTM imaging results, providing fundamental understanding of the desaturation dynamics in the PEFCs and enabling the optimization of GDL substrates and gas purge protocols accordingly.