1 September 2015 in Physics of Fluids
The friction factor for a fully developed pipe flow is examined at high Reynolds numbers up to ReD = 1.8 × 107 with high accuracy using the high Reynolds number actual flow facility “Hi-Reff” at AIST, NMIJ. The precise measurement of the friction factor is achieved by the highly accurate measurement of the flow rate, and the measurement uncertainty is estimated to be approximately 0.9% with a coverage factor of k = 2. The result examined here is obviously different from the Prandtl equation and the experimental results from the superpipe at Princeton University. The deviation of the present result from the Prandtl equation in the lower Reynolds number region is approximately 2.5% and −3% at the higher Reynolds number. For ReD < 2.0 × 105, the present friction factor obtained here agrees very well with the results at the superpipe, but a deviation is observed for ReD > 2.0 × 105, and it increases with the Reynolds number and reaches −6% at ReD = 1.0 × 107. The Kármán constant estimated by the measured friction factor is 0.385. Using inner scale variables estimated by the present friction factor, the velocity profile measured by laser Doppler velocimetry in the same measurement configuration for the friction factor is normalized in order to observe the consistency of the Kármán constants between both the measurements. The Kármán constant estimated by the measured velocity profiles for ReD > 3.0 × 105 is 0.382.
1 February 2004 in Experiments in Fluids
1 May 2003 in Experiments in Fluids
26 January 1998 in Experiments in Fluids
1 March 2009 in Flow Measurement and Instrumentation
1 May 2018 in Physics of Fluids
This paper reports further experimental results obtained in high Reynolds number actual flow facility in Japan. The experiments were performed in a pipe flow with water, and the friction Reynolds number was varied up to Reτ = 5.3 × 104. This high Reynolds number was achieved by using water as the working fluid and adopting a large-diameter pipe (387 mm) while controlling the flow rate and temperature with high accuracy and precision. The streamwise velocity was measured by laser Doppler velocimetry close to the wall, and the mean velocity profile, called log-law profile U+ = (1/κ) ln(y+) + B, is especially focused. After careful verification of the mean velocity profiles in terms of the flow rate accuracy and an evaluation of the consistency of the present results with those from previously measurements in a smaller pipe (100 mm), it was found that the value of κ asymptotically approaches a constant value of κ = 0.384.